Publicidad
Idiomas disponibles
Idiomas disponibles
Stacking Cabinet Installation
Installation Instructions for Sheetrock
If stacking, it is recommended to secure each cabinet to wall.
1.
Determine the desired oor location for the cabinet.
2.
Locate at least one wall stud and mark its location.
3.
Place the cabinet in the desired
location and secure to wall through
the cabinet's back top cleat using
appropriate hardware (not included).
4.
Once cabinet is installed, insert
dowels in cabinet's pre-drilled holes
(Fig. 3).
5.
Place second cabinet on top of the
bottom cabinet using the dowels as
your guide (Fig. 3).
NOTE: REMEMBER TO SECURE THE
TOP CABINET TO THE WALL.
6.
Any unused dowel holes can be
covered with dowel caps.
Hanging Cabinet Installation
Installation Instructions for Sheetrock
If stacking, it is recommended to secure each cabinet to wall.
1.
Determine the desired wall location for the cabinet.
2.
Locate at least one wall stud and mark its location.
3.
Determine desired height for top of cabinet and mark a
horizontal line on the wall (Fig. 4).
4.
Install the wall hanging cleat to the wall 8.5" below the marked
horizontal line using appropriate hardware (not included) (Fig. 4).
NOTE: WHEN INSTALLING THE HANGING CLEAT,
MAKE SURE THE ANGLE CUT IS FACING THE WALL.
5.
Hang the cabinet to the installed wall hanging cleat (Fig. 5).
6.
Secure cabinet to wall through the cabinet's back top cleat
using appropriate hardware (not included).
7.
Any dowel holes located on top or bottom edge of cabinet
can be covered with dowel caps.
Fig. 4
horizontal line
wall hanging
cleat
Fig. 3
Fig. 5
hanging cleat
8½"
wall hanging cleat
Installation Instructions for Concrete or Brick Wall
If stacking, it is recommended to secure each cabinet to wall.
1.
Determine the desired oor location for the cabinet.
2.
Mark the back top cleat of the cabinet with desired
location; drill a hole through the cleat and back of cabinet,
enough to make a mark on the wall.
3.
Remove cabinet and nish drilling holes in
the wall.
4.
Secure cabinet to wall by using appropriate
hardware (not included).
5.
Once cabinet is installed, insert dowels in
cabinet's pre-drilled holes (Fig. 3).
6.
Place second cabinet on top of the bottom
cabinet using the dowels as your guide
(Fig. 3).
NOTE: REMEMBER TO SECURE THE TOP
CABINET TO THE WALL.
7.
Any unused dowel holes can be covered
with dowel caps.
Installation Instructions for Concrete or Brick Wall
If stacking, it is recommended to secure each cabinet to wall.
1.
Determine the desired wall location for the cabinet.
2.
Determine desired height for top of cabinet and mark a
horizontal line on the wall (Fig. 4).
3.
Mark the hanging cleat with desired location; drill wall 8.5"
below the marked horizontal line just enough to mark the
position of installation (Fig. 4).
4.
Remove hanging cleat and nish drilling holes in the wall.
5.
Secure hanging cleat to wall by using appropriate hardware
(not included) (Fig. 4).
NOTE: WHEN INSTALLING THE HANGING CLEAT,
MAKE SURE THE ANGLE CUT IS FACING THE WALL.
6.
Hang the cabinet to the installed wall hanging cleat (Fig. 5).
7.
Mark the cabinet's back top cleat with desired location; drill
a hole through the back top cleat and back of cabinet,
enough to make a mark on the wall.
8.
Remove cabinet and nish drilling holes to the wall.
9.
Secure cabinet to wall through the cabinet's back top cleat
using appropriate hardware (not included).
10. Any dowel holes located on top or bottom edge of cabinet
can be covered with dowel caps.
3
Publicidad
