NGS Technology GT-Challenge Manual Del Operador página 5

When you have finished testing, quit by clicking on OK in the Test
window, and OK in the General window. Finally, close the Control Panel
window. Now its time to load your favorite game and start playing! Note
the actual controls for the fire buttons, throttle and brake pedals are
set within each individual game. Check your game documentation for
further details.
PS2
NOTE: Please ensure that your console is turned OFF before connecting
or disconnecting the wheel.
1. Connect the accelerator/brake pedal unit into the socket at the rear
of the Wheel.
2. Plug the correct console plug into port 1 of your console.
3. Place the accelerator/brake pedal unit in convenient location under
a table or in front of a chair within easy reach.
4. Turn "ON" your game console and load your driving game software.
You are now ready to play.
Sensitivity Adjustment
1. The wheel has three settings of steering sensitivity to suit your driving
games - High, Middle & Low.
2. To change between these three levels of sensitivity.
3. Press and Hold the Select and Start buttons for 3 seconds, a green
LED will switch ON.
4. Press the Select button to enter the sensitivity adjustment.
5. Press the Select button again to select between the following: Middle
(Green-LED illuminates) -> Highest (Green-LED flashing quickly) ->
Lowest (Green-LED flashing slowly).
6. Press the UP button on the D-pad to exit.
Button relocation
Button Relocation:
The Steering Wheel incorporates a very useful feature called Button Re-
location to re-map any control button to the most convenient and useful
button configuration for the user.
1. Press and hold the program button (or start and select) for 3 seconds
till the green led illuminates.
2. Press the button that you wish to relocate the function to, the LED
starts to flash.
3. Press the button with the function you wish to be relocated, the LED
turns OFF, the relocation is complete.
4. Repeat the above steps to relocate further control buttons.
User's Manual
5