Makita DVC860L Manual De Instrucciones página 12

Next, mount the damper on the powder filter and then
place them in the prefilter.
When installing powder filter and prefilter, align the
mounting position marking on each of them with that
one at the top of the tank.
Finally, mount the tank cover and lock it.
NOTE:
• Before using the powder filter, make sure that
prefilter and damper are always used together. It
is not allowed to install powder filter solely.
Installing the water filter (for cloth
filter model) (optional accessory)
CAUTION:
• Never pick up water or wet dust without the float
and the cloth filter or the water filter.
• For picking up wet dust, make sure that the float
cage and the float are installed on the cleaner.
• When installing the water filter on the tank, set it
tight at the opening of the tank so that the hook
of the water filter engages the tank opening
firmly and there is no space between the water
filter and the tank.
NOTICE:
• It is recommended using water filter when picking
up large amount of water repeatedly. Otherwise
vacuum ability may be reduced in case of cloth
filter.
3
3
► 1. Water filter 2. Tank 3. Mounting position marking
To pick up water or wet dust only, the water filter is more
suitable than the cloth filter.
When installing the water filter, align its mounting posi-
tion mark with the one on the tank.
Installing the paper pack (optional
accessory)
WARNING:
• When using the paper pack, also use the cloth
filter or prefilter together that is preinstalled on
the tool. Failure to use the cloth filter / prefilter
together may cause unusual noise and heat,
resulting in a fire.
CAUTION:
(For the cloth filter model)
• Never pick up water or other liquids or wet dusts
when using the paper pack. Picking up such
things may cause the paper pack breakage.
• Before using the paper pack, make sure that
powder filter (optional accessory), damper
(optional accessory) and prefilter are always
used together.
(For the powder filter model)
• Before using the paper pack, make sure that
powder filter, damper and prefilter are always
used together.
1. Remove the rubber holder.
1
1
2
► 1. Rubber holder
2. Extend the paper pack.
3. Align the paper pack opening with the dust suction
opening of the cleaner.
4. Insert the cardboard of the paper pack onto the
holder so that it is positioned at the end beyond
the detent protrusion.
1
► 1. Paper pack 2. Holder
12 ENGLISH
1
2