Signals of the PWR LED
Light signal
off
yellow permanently
yellow flashing
green permanently
green flashing
green and yellow flashing
red permanently
red flashing
red flashing and 3 seconds beep
Table 4: Signals of the PWR LED
Battery level monitoring
The RML10-STD incorporates battery level monitoring. The battery is discharging when the RML10-STD is turned
on and operational. Also, when the RML10-STD is switched off, it discharges slightly.
Low battery warning
When the battery reaches 20 % of full charge capacity the PWR LED will start flashing red.
Auto shut-down
When the battery level reaches 0 % of full charge capacity:
• An acoustic signal sounds for 3 seconds.
• The device will automatically shut down.
• The LEDs will also be switched off.
3.5 Bluetooth connection
Switching Bluetooth on or off
1. Press the BLE button for 2 seconds.
The RML10-STD is visible to other Bluetooth devices as <RML10-STD [serial number]> for 30 seconds.
P
You hear a short beep.
P
If Bluetooth is switched on: The BLE LED starts flashing blue.
P
If Bluetooth is switched off: The BLE LED stops flashing (off).
P
Pairing RML10-STD with Android® device
1. Switch Bluetooth on.
Within 30 seconds you can pair the RML10-STD to your Android device.
■
You do not need a password.
■
When the RML10-STD is paired to your Android device, the BLE LED glows blue permanently.
■
If no pairing occurs within 30 seconds, Bluetooth will be switched off.
■
After disconnecting the RML10-STD from your Androiddevice, your Androiddevice automatically switches off
■
Bluetooth.
13.02.2023
Meaning
The RML10-STD is off.
The RML10-STD is off and fully charged, but still connected to the
charger.
The RML10-STD is off and being charged.
The RML10-STD is on and fully charged, but still connected to the
charger.
The RML10-STD is on and not being charged.
The RML10-STD is on and being charged.
Charging error
The RML10-STD is on, low battery warning (<20 %).
The RML10-STD is being shut down automatically.
RML10-oi-en1h2602GE23R0223
Operation | EN
19