resideo RML10-STD Manual De Instrucciones página 20

Signals of the BLE LED
Light signal
off
blue permanently
blue flashing
green permanently
green and blue flashing
light blue
orange
orange and light blue flashing
Table 5: Signals of the BLE LED
3.6 USB connection
The RML10-STD can communicate with HMA suite only via USB connection. If the RML10-STD is connected to a
computer via USB, the creates two COM ports:
• The COM port "USB Serial Port for metering devices" is intended for use with HMA suite.
• The COM port "USB Serial Port RML10-STD" is reserved for future Windows® applications.
Signals of the BLE LED
see Kapitel 3.5, "Bluetooth
3.7 Infrared connection
Switching infrared on
1. Press the button.
Infrared operational modes
The RML10-STD can operate in the following infrared modes:
• Standard assignment of the button: The radio telegrams are started at the measuring device.
• Free assignment by the RM App: The infrared transmitter is controlled via the RM App.
• HMA suite transparent mode: The RML10-STD is connected to a Windows® computer on which HMA suite is
running.
Signals of the LED
Signal
off
yellow permanently
yellow flashing
2 seconds green, 1 second beep
2 seconds red, 3 short beeps
2 seconds yellow, 5 short beeps
Table 6: Signals of the LED
13.02.2023
Meaning
Bluetooth is off, USB is not active.
A Bluetooth connection is active.
(Note: Bluetooth has priority over USB. If both are connected only
Bluetooth is shown.)
The RML10-STD is visible via Bluetooth.
A USB connection is active.
A USB connection is active and the RML10-STD is visible via
Bluetooth.
button is under control of a connected application (e.g. RM App )
and a Bluetooth connection is active.
button is under the control of a connected application (e.g. RM App)
and Bluetooth is switched off
button is under the control of a connected application (e.g. RM App)
and Bluetooth is in pairing mode
connection", Tab. 5: Signals of the BLE LED
Meaning
The button is in meter start mode.
The function of the button is set by the RM App (RM App mode)
infrared communication in progress (only in meter start mode)
infrared communication was successful (only in meter start mode)
infrared communication error (only in meter start mode)
infrared device reported error (only in meter start mode)
RML10-oi-en1h2602GE23R0223
Operation | EN
20