Kverneland Optima TFprofi Manual Del Usuario página 6

Safety/Preparations
Safety/Preparations
Assembly work
Carrying out work
on the hydraulics
Requirements for
assembly
Screw connec-
tions
Tightening torques,
general
6
Assembly work
Assembly work must only be carried out by authorised, qualified
specialists.
Errors made when carrying out this work can cause moderate to se-
rious injury or even fatal injury.
Accident prevention regulations
The relevant accident prevention regulations must be observed.
Errors made when carrying out this work can cause moderate to se-
rious injury or even fatal injury.
The hydraulic system is under high pressure
Depressurise the hydraulic system before starting work.
Errors made when carrying out this work can cause moderate to se-
rious injury or even fatal injury.
Follow the machine operating manual
In addition to these instructions, follow the machine operating in-
structions.
This prevents false operation and damage.
Before assembly begins, the following requirements must be met:
The machine is on a flat surface and is secured against rolling away
•
The electrical system is deactivated
•
The hydraulic system is deactivated
•
The hydraulic lines are depressurised
Retightening bolts
After the first hours of operation, all bolts must be checked and
tightened if necessary.
Screw connections might have come loose due to vibrations.
Tighten all screw connections using the information provided in the ta-
ble. If different tightening torques are required, they are specified ac-
cordingly. The minimum quality of the bolts is "8.8".
The table can be found on page 23.