Publicidad
Idiomas disponibles
Idiomas disponibles
o
pERAtioN
SETUP FOR CUTTING
PLUG
machine into proper power supply
CONNECT
air supply to input on the back of the machine
ATTACH
ground clamp to bare metal on the workpiece or to metal work bench where workpiece is clamped
SWITCH
machine on
ADJUST
air supply valve (20A 50-100 PSI, 45A 80-110 PSI)
ADJUST
amperage on the front of the machine to desired settings
PULL
torch trigger to initiate pilot arc
When finished cutting, allow fans to run for 10 minutes to cool machine down. Then
power off, and disconnect air input from back of machine.
TIPS FOR CUTTING
Unnecessary igniting of the pilot arc will reduce lifespan of electrode and nozzle.
Always start cutting at the edge of the workpiece, unless you are piercing.
Keep a space between nozzle and workpiece for smoother and better cutting.
Do not rapidly switch the trigger on and off, as this will damage the pilot arc.
Always use air filter to ensure air is moisture free.
Regularly clean torch head (Do not hit torch head to remove slag).
THINNER MATERIALS
THICKER MATERIALS
Start by setting recommended amperage and adjust as necessary.
LOWER AMPS, LESS AIR PRESSURE
HIGHER AMPS, MORE AIR PRESSURE
www.ktindustries.net
6
PAGE | PAGE | PÁGINA
®
®
Publicidad
