Handlebar And Stem - BH Easy motion STAND UP Manual Del Usuario

Front wheel:
Make sure that the contact is out and remove the key. Disconnect the cable
connector, in case that the vehicle was provided with it. Loose the wheel axle
nuts counter clockwise with a fixed key. Remind the situation of the safety
washers towards the assembling.
Remove the wheel in a vertical down position.
To assemble the wheel, place the wheel at its correct position. Fit the safety
washers and tie the nuts clockwise. Connect the engine cable and check the
brakes to work properly.
Rear wheels:
To remove the rear wheel, use a tube key suitable to the nut sizes. Loose the
nut and take out the wheel. Remind the situation of the washers and the
wheels. To fit the wheels, place the washers and the wheels to their original
place and order and tie the nuts.
See section: Torque value

10.2 HANDLEBAR AND STEM

The handlebar must be centred to the stem and perpendicular to the frame.
The handlebar is fitted to the stem by a plate with 4 screws. Loose the screws
to regulate the handlebar position. To fix the handlebar position in a right
subjection, tight the screws in alternate cross form.
The handlebar height can not be changed.
HANDLEBAR FOLDING AND ADJUSTMENT
The folding of the STAND UP handlebar is easy and practical. Please check the
explication in order to get an easy and safety folding. Make sure that no cables
are over-stretched or pinched when moving the different parts
To fold the STAND UP handlebar: (A) to block the handlebar. (Figura 3) (stem
closing system ).
FOLDING: First pull out the closing lever (1) (Figure 5) (Open the closing)
move the lever down and lateral to open the safety blockade. (Arrow 2) in
(Figure 6) ( unblockade closing )
Move the stem in the rear direction. (Figure 4) (Folding)