Publicidad
Idiomas disponibles
Idiomas disponibles
the type recommended by the manufacturer.
GB
• Do not place any dangerous products, such as fuel, alcohol,
paint, aerosol cans with a flammable propellant, flammable
or explosive substances, etc. inside or near the appliance.
• Once installed, the appliance must not be tilted at an angle
greater than 5° and it is necessary to wait 2h before connect-
ing it to the power supply to switch it on. The same applies if
the appliance is moved afterwards.
• If the appliance has been switched off or disconnected from
the power supply, it is necessary to wait 5 minutes until
switching on again.
• No other appliances should be plugged into the same socket
as with this appliance.
Intended use
• This appliance is intended to be used in household and simi-
lar applications such as:
-staff kitchen areas in shops, offices and others working en-
vironment;
-farm houses;
-by clients in hotels, motels and other residential type en-
vironment;
-bed and breakfast type environment.
• The appliance is designed only for making ice cubes. Any
other use may lead to damage of the appliance or personal
injury.
• Operating the appliance for any other purpose shall be
deemed a misuse of the device. The user shall be solely liable
for improper use of the device.
Grounding installation
This appliance is classified as protection class I and must be
connected to a protective ground. Grounding reduces the risk
of electric shock by providing an escape wire for the electric
current.
This appliance is fitted with a power cord with grounding plug
or electrical connections with grounding wire. The connections
must be properly installed and grounded.
Main parts of the product
(Fig.1 on page 3)
1. Evaporator
2. Ice scoop
3. Ice full sensor
4. Ice basket
5. Back top panel
6. Air exhausting
7. Water drain cap: at front bottom side of the unit
8. Top cover with transparent window
9. Maximum water level marking
Spare parts or accessories
(Fig.2 on page 4)
10. Ice scoop
Control panel
(Fig.3 on page 4)
1. Add water indicator (water level is too low)
2. Ice full indicator
3. Power indicator
8
4. Small ice cube indicator
5. Large ice cube indicator
6. Power ON/OFF / Clean button
7. Size of ice selection
Preparation before use
• Remove all protective packaging and wrapping.
• Check that the device is in good condition and with all ac-
cessories. In case of incomplete or damaged delivery, please
contact the supplier immediately. In this case, do not use the
device.
• Clean the accessories and the appliance before use (See ==>
Cleaning & Maintenance).
• Make sure the appliance is completely dry.
• Place the appliance on a horizontal, stable and heat resistant
surface that is safe against water splashes.
• Keep the packaging if you intend to store your appliance in
the future.
• Keep the user manual for future reference.
NOTE! Due to manufacturing residues, the appliance may emit
a light odor during the first few uses. This is normal and does
not indicate any defect or hazard. Make sure the appliance is
well ventilated.
Operating instructions
Start the self-cleaning program
• Open the top cover, remove the ice basket and fill the tank
with water. Do not fill beyond the maximum water level. Make
sure the ice basket is above water
• Plug on the unit, press the "Power ON/OFF/Clean" button
for more than 5 seconds to enter the self-cleaning program.
Self-cleaning program need 30 mins. When the program is
over, drain out the water and clean inside.
Using ice maker
• Open the cover, remove the ice basket and pour water into the
tank. Keep water level below the maximum water level mark.
Note: Fill with potable water only. Only use drinking water.
• Press "ON/OFF/Clean" button to begin the ice making cycle.
• Press ice size selection button. If the room temperature is
lower than 15°C(59°F), it is recommended to select small ice
size in order to avoid ice sticking together.
• The ice making cycle lasts approx 8 to 13 minutes, depending
on the selection of ice size and the room temperature.
• If water pump can't inject water due to low water level, the
ice maker will stop automatically. Add water indicator will be
light up. Turn off the unit, fill water up to maximum water
level. Then turn on the unit again. Allow the refrigerant liq-
uid inside the compressor at least 3 minutes to settle before
restarting.
• The ice maker stops when the ice basket is full and the ice full
indicator will be light up.
WARNING: Direct sunlight or sunlight reflection may cause
infrared sensor malfunction. If the unit doesn't stop even ice
cubes obstruct sensor, move the unit where no sunlight.
• Change water in the water reservoir every 24 hours to ensure
a reasonable hygiene level. If unit isn't to be used, drain all
the water and dry the tank.
• Beware: Never tip the appliance more than 45° and do not
turn the appliance upside down. This will damage the appli-
ance beyond repair.
Publicidad
