ALFRA 03910 Manual De Instrucciones página 15

Technical data / Scope of supply
Device:
Outer dimensions L x W x
H:
weight:
Max. operating pressure:
Bending:
Bending Cu + Al max.:
Bending angle up to:
Smallest leg length:
Smallest U-bend:
Smallest Z-bend:
Scope of supply:
Art. no. 03200 Art. no. 03910 complete set 1
1 x basic device 1 x basic device
1 x safety hood 1 x safety hood
1 x control cable 1 x control cable
1 x Art. no. 03201 R10 el. angle reader
1 x Art. no. 03202 R10 bending die
1 x Art. no. 03203 length stop
1 x Art. no. 03852 electro-hydraulic pump
1 x 2 m hydraulic hose
(with two quick-release couplings)
Commissioning
1. There is an orange-coloured ventilation screw on the rear of the housing of each pump. This must be placed in the
tank opening before putting the device into operation. It replaces the oil plug screw and guarantees adequate
ventilation of the oil tank.
Transport
SC05 III-B
700 x 410 x 410 mm
60 kg
700 bar
120 x 12 mm
Over 90°
50 mm
100 mm
72 mm
(dependent on material
thickness)
SC05 III-B
Operation
Punching:
Punching Cu + Al:
Max. material
thickness:
Material width:
Art. no. 03920 complete set 1
1 x basic device
1 x safety hood
1 x control cable
1 x Art. no. 03201 R10 el. angle reader
1 x Art. no. 03202 R10 bending die
1 x Art. no. 03203 length stop
1 x Art. no. 03853 electro-hydraulic pump
1 x 2 m hydraulic hose
(with one quick-release coupling)
Ölverschlußschraube
AHP 03-1
6.6 – 21.5
Also slots up to max. 21 mm
length
12 mm
110 mm in dead centre
AHP 03-1
15