Publicidad
Idiomas disponibles
Idiomas disponibles
Periodic cleaning of your new ceiling fan is the only
maintenance necessary.
When cleaning, use only a soft brush or lint free cloth to
avoid scratching the finish.
Abrasive cleaning agents are not required and should be
avoided to prevent damage to finish.
How to Clean Your Ceiling Fan Blades
Periodic light dusting of the blades is recommended.
A feather duster will work best.
For your own safety turn off power at fuse box or circuit breaker before trouble shooting your fan.
Trouble
1. FAN WILL NOT START.
2. FAN SOUNDS NOISY.
3. FAN WOBBLES
EXCESSIVELY.
4. REMOTE CONTROL
DOES NOT WORK. THE
CONTROL INDICATOR
LED IS CONSTANTLY
FLASHING.
5. NOT ENOUGH AIR
MOVEMENT.
Maintenance
Troubleshooting
Probable Cause
1. Fuse or circuit breaker blown.
2. Loose power line connections to the fan, or loose
switch wire connections in the switch housing.
3. Dead battery in remote control.
1. Blades not attached to fan.
2. Loose screws in motor housing.
3. Wire connectors inside housing rattling.
4. Motor noise caused by solid state variable
speed control.
1. Setscrew in downrod support is loose.
2. Setscrew in downrod/hanger ball assembly is
loose.
3. Screws securing fan blade to motor assembly
are loose.
4. Hanger bracket and/or ceiling outlet box is not
securely fastened.
1. The battery/batteries are going to run out.
Do not use solvents when cleaning your ceiling fan. It
could damage the motor or the blades and create the
possibility of electrical shock.
Avoid using water, cleansers, or harsh rags, which
can warp and ruin the blades.
WARNING
1. Check main and branch circuit fuses or circuit breakers.
2. Check line wire connections to fan and switch wire
connections in the switch housings.
CAUTION: Make sure main power is turned off !
3. Replace with fresh battery.
1. Attach blades to fan before operating.
2. Check to make sure all screws in motor housing are
snug (not over-tight).
3. Check to make sure wire connectors in switch housing
are not rattling against each other or against the interior
wall of the switch housing.
CAUTION: Make sure main power is turned off !
4. Some fan motors are sensitive to signals from solid-state
variable speed controls. Solid-state controls are not
recommended, choose an alternative control method.
1. Tighten both setscrews securely in downrod support.
2. Tighten the setscrew in the downrod/hanger ball
assembly.
3. Check to be sure screws which attach the fan blade
to the motor assembly are tight.
4. Tighten the hanger bracket screws to the outlet box,
and secure outlet box.
1. Please replace the battery/batteries.
1. If possible, consider using a longer downrod (not
included, you can buy the longer downrod from
fanimation.com).
17
CAUTION
Suggested Remedy
Publicidad
