Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install
the product.
1. Do not allow children to climb or play in or around this product.
2. Use this unit for its intended purpose only. Do not use shelves as step ladder.
3. To avoid damage, assemble the product on a sturdy, level and protective surface.
4. Make sure all bolts/screws are tightly fastened before the unit is used.
5. Check bolts/screws periodically and tighten them if necessary.
MAXIMUM LOAD: 20 LBS.(9.07 KG)
WARNING
THIS UNIT IS INTENDED FOR USE ONLY WITH THE MAXIMUM WEIGHTS INDICATED. USE
WITH PRODUCTS HEAVIER THAN THE MAXIMUM WEIGHTS INDICATED MAY RESULT IN
INSTABILITY CAUSING POSSIBLE INJURY. DISTRIBUTE WEIGHT EVENLY.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents list. If any part is missing or damaged, do not attempt to
assemble the product.
Estimated Assembly Time: 50 minutes
Tools Required for Assembly (not included): Rubber Mallet, Marking Pencil, Stud Finder, Phillips
Screwdriver, Power Drill and Drill Bits.
MAXIMUM LOAD: 25 LBS.(11.33 KG)
(EVENLY DISTRIBUTED)
5
ASSEMBLY INSTRUCTIONS
1. Attach connect beams (G) and bottom stretcher (H)
between the side frames (E and F) using 1/4 in. x 12
mm bolts (AA). Tighten with hex wrench (CC).
Hardware Used
AA
1/4 in. x 12 mm Bolt
CC
Hex wrench
2. Attach top frame (B), left side frame (E) and right side
frame (F) to back posts (C) and front posts (D), using
1/4 in. x 12 mm bolts (AA). Tighten with hex wrench (CC).
Hardware Used
AA
1/4 in. x 12 mm Bolt
CC
Hex wrench
3. Attach L-bracket (DD) to assembly, using 1/4 in. x 12
mm bolts (AA). Tighten with hex wrench (CC).
Hardware Used
AA
1/4 in. x 12 mm Bolt
CC
Hex wrench
DD
L-bracket
1
F
H
CC
AA
x 4
G
x 1
G
2
CC
AA
x 10
C
F
x 1
D
E
3
CC
AA
x 16
DD
F
C
x 1
x 4
E
6
E
B
AA
B
Publicidad
