Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
1. Installing the handle
•
Place the mower upright in vertical position.
•
Remove the packing material from the cable.
•
Remove the rubber edge guard from the
upper handle.
•
Insert the upper handle (L) into the lower
handle (C).
•
Put the bolts (AA) through the holes and
tighten with the nuts (AA), using a philips
head screwdriver (not included).
Hardware Used
Handle bolt and
AA
nut kit
2. Unfolding and adjusting handle
•
Pull up on the handle holes (K) to release the
handles.
•
Fold the handles up until the handle pins lock
into position.
Note: Make sure that the two handle pins are in
the same position.
3. Installing the grass catcher
•
Remove the mulch plug.
•
Open the rear discharge door and hold it.
•
Hold the the grass catcher (J) by its handle
and engage the hooks on the slots.
•
Close the rear discharge door.
1
L
L
C
x 2
2
3
13
K
J
AA
Publicidad
