Publicidad
Idiomas disponibles
Idiomas disponibles
Attaching, removing the tool
Risk of severe injuries.
Clean the tool insertion end prior to
¾
use and grease with the enclosed
special grease! Use only SDS-max
tools.
Risk of severe injuries.
The dust cap [6] prevents the ingress of
drilling dust during operation.
Ensure the dust cap [6] is not
¾
damaged when inserting the tool.
Tool attachment
▸
When inserting the tool, hold the tool lock [7] in
the forward position.
▸
Rotate the tool and insert until it engages.
The tool is locked.
3
Attention!
▸
Pull on the tool to check that it is correctly
seated. (It must be possible for the tool to move
a few centimetres in the axial direction.)
Tool removal
▸
Pull the tool lock [7] backwards in the direction of
the arrow (a) and remove the tool (b).
Adjusting the operating mode
and chisel position
Attention!
Do not move the lever on the machine when the
chisel is clamped.
BMH 40 BASIC:
Attention!
▸
Only press button [9] when the motor is sta-
tionary.
WARNING!
WARNING!
▸
Select the desired operating mode by rotating
button [9].
Hammer drilling
Chiselling
Position for turning the chisel to the
desired position.
▸
Adjusting the position of the chisel: The chisel can
be locked in different positions.
▸
Insert the chisel.
▸
Turn button [9] to the intermediate position .
▸
Turn the chisel until it is located in the desired
position.
▸
Turn button [9] to position .
▸
Turn the chisel until it latches in place.
Risk of severe injuries.
▸
Only operate the machine in chisel
mode
MH 5 BASIC:
▸
Insert the chisel.
▸
Push the sleeve [8] forwards and turn the chisel
until it is located in the desired position.
▸
Push the sleeve [8] backwards / release.
▸
Turn the chisel until it latches in place.
Switching on/off
Non-continuous operation
▸
Press trigger switch [12] to switch the machine on.
▸
Release trigger switch [12] to switch off.
Continuous operation (only in chisel
mode
):
▸
Press and hold button [10] for continuous oper-
ation.
▸
To switch off, press button [10] again.
Risk of severe injuries.
If the machine is set to continuous run-
Â
ning, it will continue to run if it is torn
out of your hand.
Always hold the machine with both
¾
hands at the handles provided, take
up a stable posture and concentrate
on the work in hand.
WARNING!
when the chisel is inserted.
WARNING!
15
Publicidad
