Publicidad
Idiomas disponibles
Idiomas disponibles
Adjusting the impact strength
▸
Change the impact strength (and speed) by
rotating setting wheel [16].
▸
The impact strength is increased from position 1 to
5 and the operation mode indicator [14] flashes.
▸
The tool delivers maximum impact strength in
position 6; the operation mode indicator [14] is
on continuously in this position.
Application
Plaster/light building materials
Bricks/removal of ceramic/floor tiles
Drilling/chiselling in concrete
Integrated damping system
For reduced vibration and thus joint-friendly working.
▸
Do not press the machine too lightly or too
severely on the rear handle.
▸
Vibration suppression is most effective in the
middle position [11].
Maintenance and cleaning
Risk of injuries or property damage due
to improper actions.
Do not open the device.
¾
The device must only be opened by a
¾
Würth service technician.
Observe the relevant safety and
¾
accident prevention regulations
during all maintenance and servicing
work.
Danger posed by electric current.
Carry out maintenance and cleaning
¾
work on the device only when the
mains plug has been removed.
Dusts from materials can be harmful to
health.
Wear safety glasses and a dust mask
¾
or respirator.
16
Setting
wheel
CAUTION!
WARNING!
CAUTION!
Motor cleaning
▸
Blow out the machine with compressed air through
the rear ventilation slots regularly, frequently and
thoroughly. Hold the machine firmly while blowing
out.
Changing the dust cap
▸
A damaged dust cap [6] must be replaced
immediately.
▸
1-2
To replace the dust cap [6] push the tool lock [7]
backwards.
3-4
▸
Grip the dust cap and pull off forcefully.
5-6
▸
Position the new dust cap inclined at an angle on
the spindle and push on forcefully.
Troubleshooting
Overload
The machine has stopped automatically.
The signal indicator [15] is on.
The machine has been overloaded (approx.
Â
30%)!
Allow the machine to cool, only then will you
¾
be able to continue working. Avoid further
overloading.
Restarting protection
Machine not running. The signal indica-
tor [15] is on.
The restart protection device has tripped. If the
Â
mains plug is inserted with the machine switched
on, or if the power supply is restored after an
interruption, the machine does not start.
Switch the machine off and on again.
¾
Carbon brushes worn
The signal indicator [15] flashes.
The carbon brushes are nearly completely worn
Â
away (remaining running time, about 8 hours). If
the carbon brushes are completely worn away,
the machine switches off automatically.
Arrange for Würth masterService to change the
¾
carbon brushes.
Attention!
Publicidad
