Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
10. Locate the two Door Panels (N). Align the
Hinges (GG) with the holes in the Door Panels
(N). Attach the four Hinges (GG) with eight
Hinge Screws (HH). Fully tighten the Hinge
Screws (HH) with a screwdriver. Align the door
assemblies to the mantel assembly by aligning
the holes in the Hinges (GG) with the inside
panels. Attach the doors with sixteen Hinge
Screws (HH). Fully tighten the Hinge Screws
(HH) with a screwdriver. Adjust the vertical
height by loosening the four screws, "A" in the
diagram, on both hinges. Adjust up or down by
a few mm, if needed. Then tighten the screws
again. Adjust the depth by loosening "B" screw,
in the diagram, and adjust the door. If the
door cannot be adjusted, please loosen screw
"C", as shown in the diagram, then try again.
Tighten screw "B" and "C" as shown in the
diagram. Adjust the cabinet doors sideways by
turning the screw "C" on both hinges on each
door.
11. Insert four Shelf Pins (FF) into the shelf pin
holes in the cabinet. Place Adjustable Shelf (K)
on the Shelf Pins (FF).
12. Insert the firebox into the mantel through the
back opening. Push the firebox forward through
the back opening until the metal trim of the
firebox is flush with the side surrounds. Once
the firebox is in position, attach the firebox by
inserting and tightening six Firebox Screws
(KK) through the mounting brackets and into
the surround trims.
10
GG
N
11
FF
K
12
KK
7
HH
A
B
C
Publicidad
