Descargar Imprimir esta página

Black and Decker PW1500 Manual De Instrucciones página 10

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING
GUIDE
Symptom
Solution
Motor does not start.
Plug in power cord.
Turn switch to the "On" position.
Squeeze trigger with switch in
"ON" position.
Press reset button at GFCI on plug
end of cord.
Unit does not reach Water faucet not fully
Open water valve fully.
I
Cause
Unit not plugged in.
On/Off switch is in the Off
)osition.
Wand trigger not being
squeezed.
GFCI tripped.
high pressure,
turned on.
Water inlet filter clogged.
Nozzle worn.
Pump is sucking air.
Water supply restricted.
Output pressure
Not enough inlet water
varies high/low,
supply.
Pump is sucking air.
No detergent.
Garden hose
connection leaks.
Spray wand or
extension leaks.
Water inlet filter clogged.
Discharge nozzle is
obstructed.
Detergent container is
empty.
Detergent bottle or suction
tube not properly
connected.
Detergent is too thick.
Filter on detergent suction
tube is clogged.
Damaged or clogged
detergent suction tube.
Discharge nozzle is
obstructed.
Loose fittings.
Missing/worn rubber
washer.
Spray wand not properly
attached.
Remove filter and rinse to clean.
Contact B&D Customer Service
Representative
at 1-800-544-6986.
Check that hoses and fittings are air
tight. Turn off machine and purge
pump by squeezing trigger gun until a
steady flow of water emerges from the
nozzle.
Check water hose for kinks, leaks and
blockage.
Turn water on full force - check hose
for leaks and kinks.
Check that hoses and fittings are air
tight. Turn off machine and purge
pump by squeezing trigger gun until a
steady flow of water emerges from the
nozzle.
Remove filter (B1) and rinseto dean. Fig.L
Blow out or remove debris with tool
)rovided.
Add more detergent.
Check connections.
Use detergent recommended
for use
in pressure washers only.
Run warm water through filter to
remove debris.
Remove obstruction or replace
detergent suction tube.
Blow out or remove debris with tool
)rovided.
Tighten fittings.
Replace washer in hose adapter.
Insert the spray wand into the wand
extension. Push in and turn to lock
spray wand into place.
10

Publicidad

loading