Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push the battery latch lock
to the side and squeeze the battery latch lever. Pull
the battery pack away from the machine.
Always remove the battery pack
WARNING
any time the tool is not in use.
To insert the battery, slide the pack into the body of
the machine. Make sure it latches securely into place.
Only use accessories specifi-
WARNING
cally recommended for this
machine. Others may be hazardous.
Selecting Wheel and Outer Flange
To reduce the risk of injury, use a
WARNING
cut-off wheel which is rated with a
maximum safe operating speed at least 5370 RPM.
READ SAFETY INFORMATION SUPPLIED WITH
CUT-OFF WHEEL. Always wear proper safety
equipment, including a dust mask.
Use only the proper wheel made for this tool. DO
NOT USE ANY TYPE OF SAW BLADE. USE ONLY
TYPE "1" ABRASIVE and DIAMOND WHEELS.
Match the appropriate outer flange for the wheel
type to reduce the risk of personal injury.
The small flange (2") can ONLY be used with
Diamond Wheels.
The large flange (4") can be used with both Abra-
sive Wheels and Diamond Wheels.
Installing and Removing Cut-Off Wheels
Wheels are sharp. Wear work
WARNING
gloves when handling wheels.
1. WARNING! Remove battery to avoid starting the
machine.
2. Place machine on a firm surface.
3. Move wheel guard for easier access to spindle bolt.
4. Slide the inner flange, arbor adapter, cut-off wheel,
and outer flange over the spindle. Be sure the
arbor adapter matches the wheel arbor hole size
(20 mm or 1").
Spindle
Inner
flange
Arbor adapter
5. While holding the spindle lock in place with the
hex wrench (1), install and tighten the spindle bolt
securely with the scrench (2).
1
2
6. To remove cut-off wheels, hold the spindle lock
in place and loosen the spindle bolt with the
scrench. Remove the spindle bolt, outer flange,
arbor adapter, and cut-off wheel.
Adjusting the Wheel Guard
To reduce the risk of injury when
WARNING
cutting, ALWAYS adjust the wheel
guard to provide the best control and protection.
Wear gloves to protect hands when adjusting the
guard.
1. WARNING! Remove battery to avoid starting the
machine.
2. Grasp the wheel guard
handle and rotate for-
ward or backward (45º
range). Always position
the guard in the loca-
tion which offers best
control and protection.
ONE-KEY™
To learn more about the ONE-KEY™ functionality
for this tool, go to milwaukeetool.com/One-Key. To
download the ONE-KEY™ app, visit the App Store
or Google Play™ from your smart device.
ONE-KEY™ Indicator
Solid Blue
Wireless mode is active and
ready to be configured via the
ONE-KEY™ app.
Blinking Blue Tool is actively communicating with
the ONE-KEY™ app.
Blinking Red Tool is in security lockout and can
be unlocked by the owner via the
ONE-KEY™ app.
6
Wheel
Outer flange
Spindle bolt
®
Publicidad
