Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly - Close-To-Ceiling Mount
1
Preparing for mounting
□
Remove canopy ring (M) from the canopy (C) by turning the
ring to the right until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the four canopy screws (HH) on the top of the
canopy (C). Remove the two non-slotted canopy screws (HH)
and loosen the slotted canopy screws (HH).
□
Remove the decorative canopy bottom cover (N) from the
canopy (C) by depressing the three studs.
Assembly - Hanging the Fan
1
Attaching the fan to the electrical
box
WARNING: To reduce the risk of fire, electric shock
or personal injury, mount to an outlet box marked
"Acceptable for fan support of 35 lbs. (15.9 Kg) or less,"
and use the screws provided with the outlet box.
□
Pass the 120-Volt supply wires through the center hole in the
mounting bracket (A).
□
Install the slide-on mounting bracket (A) on the outlet box by
sliding the slide-on mounting bracket (A) over the two screws (1)
provided with the outlet box. If necessary, use leveling washers
(not included) between the slide-on mounting bracket (A) and
the outlet box. The flat side of the slide-on mounting bracket (A)
should face toward the outlet box, as shown.
□
Securely tighten the two mounting screws (1).
2
Routing the wires
□
Remove three of the six screws and lock washers (PP)
(every other one) securing the motor collar to the top of the
fan-motor assembly (E).
□
Place the rubber gasket (FF) over the remaining three
screws, route the wires exiting the top of the fan-motor
assembly (E) through the canopy ring (make sure the slot
opening are on top), then proceed to place the ceiling
canopy (C) over the collar at the top of the motor.
□
Align the mounting holes with the holes in the motor and
fasten, using the three screws and lock-washers (PP) re-
A
moved previously. Tighten the mounting screws securely.
HH
C
N
M
2
Hanging the fan
□
Carefully lift the fan-motor assembly (E) up to the slide-on
mounting bracket (A).
□
Seat the hanger ball portion of the ball/downrod assembly (B)
in the slide-on mounting bracket (A) socket. Ensure that the tab
on the slide-on mounting bracket (A) socket is properly seated
in the groove in the hanger ball. If using close-to-ceiling
mounting, hang the fan on the hook provided by utilizing one
of the holes at the outer rim of the ceiling canopy (C).
8
PP
WARNING: The hook is only to balance the fan while making
the electrical connections. Failure to hang as shown may
result in the hook breaking, causing the fan to fall. The hook
must pass from the inside to the outside of the canopy.
A
C
E
C
FF
E
A
B
C
E
Publicidad
