Arizant Healthcare 3M SpotOn 36000 Instrucciones De Uso página 4

Instructions for use
1. Ensure the SpotOn power cord is connected to the back of the control unit
and the power cord is plugged into an appropriate outlet. If desired, ensure the
provided monitor cable is connected to the back of the SpotOn control unit and
to the YSI-400 type input on the patient monitor.
2. Use an alcohol wipe to clean and disinfect the patient's forehead above the
orbital ridge. Allow the patient's forehead to completely dry.
3. Connect the SpotOn temperature sensor to the sensor cable connector. Ensure
the sensor tab is properly connected and is fully inserted into the SpotOn sensor
cable connector (Figure 1).
sensor tab
Figure 1: Connect the SpotOn temperature sensor to the sensor cable
4. Remove backing liners on the SpotOn temperature sensor to expose adhesive
(Figure 2).
Figure 2: Remove the backing liners
connector
-4-