Olsson and Brothers Stroot Manual De Instrucciones página 19

Idiomas disponibles

Make sure the battery does not reach temperatures above 50 ° C, or below minus 10 ° C

for extended periods of time. (For example, do not leave the electric scooter inside a hot

car in summer, do not put the batteries in the fire)

Low temperatures (for example, temperatures below freezing) can damage battery cells.

Keep the electric scooter away from any open flame or other sources of heat to pre-

vent the battery from getting too hot. Also make sure not to leave the electric scooter

in very cold temperatures.

Both excessive heat and cold can cause the battery to discharge and can damage it.

Use only the original charger, as each battery requires a specific charger, and if you use

other chargers, this may cause damage to the product.

Do not overcharge or discharge the battery.

Be sure to charge the battery before it runs out of charge, to avoid damaging the bat-

tery cells. (The warranty does not cover the damaged battery caused by improper use)

Dismantling the battery is prohibited. Can only be handled by the official Olsson re-

pair service center.

BEARINGS, SCREWS, BRAKES AND WHEELS

The electric scooter is made up of moving parts, which over time will be susceptible to

wear.

BEARINGS AND SCREWS

The electric scooter has sealed, dust-proof bearings so lubrication is not necessary.

Check bearing wear at regular intervals to avoid unsafe driving.

Do not go up and down and do not apply excessive force to avoid damaging the bea-

rings. This is not a sports scooter, it is for children's use.

Make sure that all screws are properly tightened to avoid dangerous situations.

Check the screws regularly and tighten them if they appear loose.

BRAKES

Check the rear brake periodically for wear at regular intervals to avoid unsafe driving.

Do not apply excessive force to avoid damaging the brake.

RUEDAS

Check wheel wear at regular intervals to avoid unsafe driving.

If the wheel appears to bulge even after the bolts are tightened, the bearings may be

worn and require replacement.