Publicidad
Idiomas disponibles
Idiomas disponibles
• In dusty
conditions,
slightly
dampen
sur-
faces or use a mister attachment
when wa-
ter is available.
• Conserve
water
by using
power
blowers
instead of hoses for many lawn and garden
applications,
including areas such as gutters,
screens, patios, grills, porches, and gardens.
• Watch out for children, pets, open windows,
or freshly
washed
cars.
Blow debris away
safely.
• Use the full blower nozzle extension
so the
air stream can work close to the ground.
• After using blowers
and other equipment,
CLEAN
UP! Dispose
of debris
in trash re-
ceptacles.
BEFORE
STARTING
ENGINE
_WARNING:
Be sure to read the fuel
information
in the safety rules before you be-
gin. if you do not understand
the safety rules,
do
not
attempt
to
fuel
your
unit.
Call
1-800-554-6723.
FUELING
ENGINE
WARNING:
Remove fuel cap slowly
when refueling.
HELPFUL
TIP
To obtain the correct oil mix
I
ratio,
pour 3.2 ounces
of
2-cycle
synthetic
off into
one gaflon of fresh gas.
This
engine
is
certified
to
operate
on
unleaded
gasoline.
Before
operation,
gasoline
must be mixed with a good quality
synthetic
2-cycle
air-cooled
engine
oil
designed
to be mixed at a ratio of 40:1. Poulan
PRO brand
synthetic
oil is recommended.
Mix gasoline
and oil at a ratio of 40:1.
A 40:1
ratio is obtained by mixing 3.2 ounces (95 ml)
d
oil with
1 gallon
(4 liters)
of unleaded
gasoline.
DO NOT
USE automotive
oil or
marine
oil.
These
oils will
cause
engine
damage.
When
mixing
fuel
follow
instructions
printed on container.
Once oil is
added
to
gasoline,
shake
container
momentarily
to
assure
that
the
fuel
is
thoroughly
mixed. Always read and follow the
safety rules relating to fuel before fueling your
unit.
IMPORTANT
Experience
indicates
that
alcohol
blended
fuels
(called
gasohol
or using
ethanol
or
methanol)
can attract moisture which teads to
separation
and formation
of acids
during
storage.
Acidic
gas
can
damage
the fuel
system of an engine while in storage. To avoid
engine
problems,
empty
the
fuel
system
before storage for 30 days or longer. Drain the
gas tank, start the engine and let it run until the
fuel lines and carburetor
are empty. Use fresh
fuel
next
season.
Never
use
engine
or
carburetor
cleaner products
in the fuel tank or
permanent
damage
may occur.
NOTE:
Unit must be placed on its side when
adding fuel (see illustration below).
TO STOP
THE
ENGINE
• To stop the engine,
move the throttle lever
to the STOP position.
BEFORE
STARTING
THE
ENGINE
_2&WARNING:
You MUST
make
sure
the tubes are secure before using the unit.
•
Fuel engine. Move at least 10 feet (3 me-
ters) away from the fueling site.
•
Hold the unit in the starting
position
as
shown.
Make sure the blower
end is di-
rected away from people,
animals, glass,
and solid objects.
STARTING
POSITION
Blower
Vacuum
wmWARNING:
When
starting
engine,
hold the unit as illustrated. Do not set unit on any
surface except a clean, hard area when starting
engine or while engine is running. Debris such
as gravel, sand,
dust, grass,
etc. could be
picked up by the air intake and thrown out
through the discharge opening, damaging
the
unit or property, or causing serious injury to by-
standers or the operator.
HELPFUL
TIP
I
!f your engine still does not
I
start
after
following
these
instructions,
pleas e
car!
1-800-554-6723.
-8-
Publicidad
