Silvercrest SHBS 3.7 D5 Instrucciones De Servicio página 27

6.4 Cutting hair
Hair trimmer attachment
NOTES:
• The hair to be dressed must be dry.
• The cutting length may deviate depending
on the cutting angle.
• Place a sheet or cape around throat and
neck to prevent cut-off hair from drop-
ping into the collar.
• Comb the hair well.
• First, start with a comb attachment 2
with a longer cutting length and then, in
the course of the cutting process, use
shorter cutting lengths step by step.
Figure C: with the comb attachment
with dial 3 you also start with a longer
cutting length. Turn the dial...
... anticlockwise to shorten the cutting
length and
... clockwise to lengthen it.
• Start by cutting the hair in the neck or on
the sides and cut towards the centre of
the head. Then, cut the front section of the
hair towards the centre of the head.
• Hold the hair and beard trimmer 6 in
such a way that the comb attachment 2
lies as flat as possible on the head.
Move the device evenly through the
hair.
Figure D: hold the hair and beard trim-
mer 6 with comb attachment 3 in such a
way that the flat area above the dial lies
on the head.
• If possible, cut against direction of hair
growth.
• In order to catch all the hair, move the
hair and beard trimmer 6 several times
through each section of the hair.
• Comb the hair repeatedly and well.
• Using the switch for cutting length fine
tuning 7 the cutting length can be slight-
ly varied with three levels (1: 1.8 mm –
3: 0.8 mm).
• In order to achieve a straight cutting line
for cutting lengths over 12 mm, the hair
15
and beard trimmer 6 should be passed
through the hair several times from dif-
ferent directions.
6.5 Trimming a beard
Beard trimmer attachment
NOTE: please note that the cutting lengths
will only be achieved if the switch for cutting
length fine tuning 7 is at position 1 and the
hair and beard trimmer 6 is held at a right
angle to the skin surface.
• Comb the beard in the direction that it
grows.
• Trim the beard downwards from ear to
chin. First trim one side, then the other.
• Comb attachment 1
Figure E: adjust the cutting length with
the slider according to the desired hair
length and read off the cutting length us-
ing the marking on the side of the comb
attachment 1 (3, 4, 5, 6 mm). Now,
shorten your beard step-by-step.
• Use the beard trimmer attachment 16
without a comb attachment 1, to cut the
beard very short or to cut a moustache
and hairline.
• Using the switch for cutting length fine
tuning 7 the cutting length can be slight-
ly varied with three levels (1: 1.8 mm –
3: 0.8 mm).
• To trim your moustache, first comb it
straight downwards. Then use either the
beard trimmer attachment 16 or the
precision trimmer attachment 5. Start at
the centre above the mouth and trim first
one side, then the other.
16
25
GB