Silvercrest SHBS 3.7 D5 Guía Breve página 14

Packing materials are not children's
toys. Children should not be allowed to
play with the plastic bags: There is a
risk of suffocation.
Keep the device out of the reach of chil-
dren.
Electrical devices can represent a haz-
ard to pets and livestock. In addition,
animals can also cause damage to the
device. For this reason you should keep
animals away from electrical devices at
all times.
Protect the device from moisture, water
drops and water splashes.
Never touch the device with wet hands.
The device, the battery charger and the
power unit must not fall into water or
other liquids and must not be rinsed un-
der running water.
If the device has fallen into water, pull
out the power unit immediately, and
only then remove the device from the
water. Do not use the device again, but
have this checked by a specialist.
Should liquid enter the device, have it
checked before starting the device up
again.
If the device is used in a bathroom, the
power unit must be pulled out after use,
as the proximity of water represents a
hazard, even when the device is
switched off.
Installation of a residual current device
(FI/RCD) with a rated residual operat-
ing current of no more than 30 mA is
recommended to provide additional
protection. Ask your electrician for ad-
vice. The installation should only be car-
ried out by a qualified electrician.
Never put the device into operation if
there are visible damages to the device,
the battery charger or the cable or if the
device has been dropped before.
Connect the cable to the device/battery
charger before plugging the power unit
into a wall socket.
12 GB
Only connect the power unit to a proper-
ly installed, easily accessible wall socket,
the voltage of which corresponds to the
specifications on the rating plate. The
wall socket must continue to be easily ac-
cessible after the device is plugged in.
Ensure that the cable cannot be dam-
aged by sharp edges or hot surfaces.
Ensure that the cable is not trapped or
crushed.
When removing the power unit from the
wall socket, always pull the power unit
and never the cable.
Pull the power unit out of the wall sock-
et, ...
... after every use,
... after each charging process,
... if there is a fault,
... before connecting the device to the
cable,
... before you clean the device and
... during thunderstorms.
To avoid any risk, do not make modifi-
cations to the device. Repairs must be
carried out by a specialist workshop or
the Service Centre.
Protect the battery against mechanical
damages. Fire hazard!
Do not expose the device to direct sun-
shine or heat. The ambient temperature
should not be lower than -10 °C and
higher than +40 °C.
The charge contacts on the device must
not be connected by metallic objects.
The battery may only be charged with
the original accessory (power unit).
Should the electrolyte solution leak out
of the battery, avoid contact with eyes,
mucous membranes and skin. Rinse im-
mediately with plenty of clean water
and consult a doctor. The electrolyte
solution can cause irritation.