Publicidad
Idiomas disponibles
Idiomas disponibles
Step 6: Connect the front section to the
middle section
Front
section
Middle
section
Step 7: Attach the phasing lines
Phasing
On the front section (the one you unfolded
in step 5), find the word "Front" stamped in
red on the boom. Find the same stamp on
the boom of the middle section. Line up both
booms so that the stamps face you.
Remove the screw and nut from end of the
middle section closest to the front section.
Insert the crimped end of the front section into
the middle section as illustrated on the left.
NOTE: Make sure the stamped words "Front" on
the two sections are lined up.
Once the front section is in place, re-insert
the screw and install the nut to secure the two
sections together.
Find the washers and 10/32" hex nuts in the
hardware bag.
line
Place the phasing lines from the front section
over the studs on the middle section. Attach the
washers and 10/32" hex nuts.
Publicidad
