Publicidad
Idiomas disponibles
Idiomas disponibles
Step 8: Attach the mast clamp insert
U-bolt
Mast clamp insert
Step 9: Install the transformer
Transformer
lead
Transformer
Step 10: Insert end caps
Find the U-bolt and mast clamp insert (see
the illustration to the left). Put the U-bolt
into the mast clamp insert with the teeth of
the mast clamp insert facing the closed end
of the U-bolt.
Mast
Insert the U-bolt into the mast clamp on
clamp
the antenna and loosely thread the 1/4"
hex nuts onto the U-bolt. The teeth on
the mast clamp and the teeth on the insert
should be facing the same direction.
Do not tighten the hex nuts yet.
Find the 10/32" hex nuts and washers in your
hardware bag.
Post
Find the small elements between the reflector
booms. These elements have posts at their
bases.
Place two washers on each post. Then position
the transformer leads between the two washers
as shown here.
Finally, tighten the hex nuts to secure the leads.
Insert the plastic end caps in the ends of the
booms as shown here. Use a rubber mallet to
gently tap them into the antenna booms to
secure them.
Publicidad
