Publicidad
Idiomas disponibles
Idiomas disponibles
1.
Use Figure 1-14 below to identify which mounting holes
to use in mounting the Left Roller Bracket (#6) to the
deck. Fabricated Decks - Use mounting hole locations "A".
Stamped Decks - Use mounting hole locations "B"
A
Figure 1-14
Note: The following figures illustrate the procedure of
installing this kit on a fabricated deck. Use the proper
mounting holes when installing your striper kit.
2.
Install the Left and Right Roller Brackets (#6 & #7) to the
location shown in Figure 1-14 on the Tractors deck with
two Hex-head Capscrews (#1) and two 5/16 Lock Nuts (#3) per
side. See Figure 1-15.
Note: The brackets mount to the OUTSIDE of the deck's
mounting brackets.
B
3.
4.
Figure 1-15
Align the four Rollers (#5) inside the brackets and slide the
Roller Pin (#2) through the center of the rollers and into the
mounting hole of the Right Roller Bracket (#7). ensuring
that the J-hook end of the pin is secured in the bracket's
mounting hole. See Figure 1-16.
Secure the end on the Roller Pin with a 1/2 Lock Nut (#4). See
Figure 1-16.
Figure 1-16
S
2 — i
ection
nStallation
7
Publicidad
