Publicidad
Idiomas disponibles
Idiomas disponibles
Link remote control to wireless network (optional)
WIRELESS SETUP
Press to link another
zone panel
YES
CONNECT MORE?
Link outdoor sensor to wireless network (optional)
Press and release
CONNECT
Press to save
and exit
NO
Español: vea la página 16 • Français : voir la page 31
1 Make sure the Connected light on the
wireless adapter is flashing.
2 Press
CONNECT
be a short delay as the r emote seeks
a signal from the wireless network.
3 When the screen displays
"Connected," press
4 Press
at the next screen to save
NO
and exit. (Or press
steps 1-4 to link another zone panel.)
If E1 appears, see error codes on page 12.
The linking procedure may time out if there is
no keypress within 30 minutes. To begin again,
press and hold the blank space (or arrow if
present) in the lower right cor ner of the screen
until the display changes (about 3 seconds)
1 Make sure the Connected light on the
wireless adapter is flashing.
2 Press the
CONNECT
of the sensor.
3 Check thermostat to verify that the
outdoor sensor is working. After
about 15 seconds, the thermostat
should display outdoor temperature
and humidity.
(If you are installing more than one zone
panel, repeat steps 1-3 for each.)
5
at the remote. There will
.
DONE
and repeat
YES
button on the back
Publicidad
