Edirol UA-5 Guía De Iniciación página 11

3. Input impedance select switch
Depending on the device connected to Input jack 2, use this switch to select either
high impedance (Hi-Z) or low impedance (Lo-Z). If you are connecting a guitar or
bass to Input jack 2, set this switch to the high impedance setting (Hi-Z).
4. Phantom power switch
This is an on/off switch for the phantom power that is supplied to XLR-type Input
jacks 1 and 2.
* If devices that do not require phantom power are connected to the XLR jacks, you must turn
the Phantom power switch off to prevent malfunction.
5. Peak indicator
This indicator allows you to avoid distorting the audio sources connected to Input
jacks 1 and 2 and the Input jacks 3 and 4. The Peak indicator will light in red at
the level at which the sound begins to distort (-3 dB). Adjust the Input sensitivity
knobs so that the Peak indicator does not light.
6. Recording source select switch
This selects the input jack that will be sent via USB to the computer as the recording
source.
DIGITAL->
The input of the Digital input connector (coaxial or optical) will be sent to the
computer. Use the Digital input selector select to select the jack that will be used
for digital input.
ANALOG->
The analog audio signals being input to Input jacks 1 and 2 and the Input jacks 3
and 4 will be sent to the computer. The audio signals from Input jacks 1 and 2 that
have passed through the Input sensitivity knob, together with the analog audio
signals from the Input jacks 3 and 4 that have passed through the Input jacks 3
and 4 adjustment volume, will be sent as audio data to the computer. For details
refer to the Block diagram (p. 14).
7. Sampling frequency select switch
This selects the Sampling frequency at which audio signals will be recorded and
played back. In order for this setting to take effect, you must exit all applications,
then switch the UA-5's power off, then on again.
About the Sampling frequency select switch setting
• The UA-5's Sampling frequency select switch must be set to match the
sampling frequency of the application you are using.
• 96 kHz REC and 96 kHz PLAY are valid only in Advanced mode (when
the Mode select switch is ON).
• When the Sampling frequency select switch is in the 96 kHz REC
position, you will not hear the playback sound from your application.
• When the Sampling frequency select switch is in the 96 kHz PLAY
position, the sound from the instrument or audio device connected to the
UA-5 cannot be recorded by your application.
Names of things and what they do
11