Publicidad
Idiomas disponibles
Idiomas disponibles
□
Pull on the pull switch
LED light off.
Switching the ceiling fan on
(see Fig. J)
□
Pull on the pull switch
fan on. The ceiling fan will run at high speed.
□
Pull on the pull switch
will run at medium speed.
□
Pull on the pull switch
will run at low speed.
□
Pull on the pull switch
ceiling fan off.
WARNING!
If you notice unusual
oscillations, stop using the ceiling fan immediately
and consult qualified personnel. Do not attempt to
repair the ceiling fan yourself.
Replacing the LED light bulb
WARNING!
DANGER OF ELECTRIC
SHOCK!
Before changing the light bulb, make sure
that the power supply to which the product is
connected is not live. To do so, remove the fuse
or switch off the circuit breaker in the fuse box
(position 0).
CAUTION! RISK OF BURNS DUE TO
HOT SURFACES! Allow the LED light to cool
off completely.
□
Remove the lampshade
4a
unit
by unscrew the thumb screws
□
Use a clean, lint-free cloth to replace the bulb.
□
Unscrew the defective LED light bulb
7
the socket
anti-clockwise.
□
Screw the new LED light bulb
7
the socket
.
□
Please refer to the chapter "Technical data" to
find out which LED light bulb is required.
10
□
Place the lampshade
unit by screw the thumb screws
□
Replace the fuse or switch on the circuit breaker
(I setting) in the fuse box.
8
again to switch the
6
to switch the ceiling
6
again. The ceiling fan
6
again. The ceiling fan
6
again to switch the
10
from the lighting
5
.
9
from
9
clockwise into
back on the lighting
5
(see Fig. I).
Setting the right/left rotation (see Fig. J)
CAUTION! RISK OF INJURY! Always
switch the ceiling fan off and wait until it is still
before using the rotation direction switch
Operating the rotation direction switch while
the ceiling fan is on can lead to injuries
and/or material damage.
□
In low temperatures, slide the rotation direction
4
switch
upwards. The ceiling fan will
distribute the warmth in the room.
□
In high temperatures, slide the rotation
4
direction switch
downwards. The ceiling fan
will create a cooling flow of air.
Troubleshooting
Error
Ceiling fan runs out of round and wobbles a
lot during operation.
Reason
Different distances of the rotor blades to the
ceiling, incorrectly mounted rotor blades.
Solution
□
Operate the ceiling fan for a longer
period of time (several hours) and then
check an even distance of the rotor blades
to the ceiling.
□
If this does not achieve the desired effect,
contact our service department.
Maintenance and cleaning
WARNING! DANGER OF ELECTRIC
SHOCK! Always disconnect the product
from the mains before cleaning. To do
so, remove the fuse or switch off the circuit breaker
in the fuse box (position 0).
WARNING! DANGER OF
ELECTRIC SHOCK! To ensure
electrical safety, never clean the product
with aggressive detergents or immerse it in water.
4
.
GB/IE/NI/CY/MT
11
Publicidad
