Transportation and storage
•
For storage and transportation of the product and
fuel, make sure that there are no leaks or fumes.
Sparks or open flames, for example from electrical
devices or boilers, can start a fire.
•
Always use approved containers for storage and
transportation of fuel.
•
Empty the fuel and chain oil tanks before
transportation or before long-term storage. Discard
the fuel and chain oil at an applicable disposal
location.
•
Use the transportation guard on the product to
prevent injuries or damage to the product. A saw
chain that does not move can also cause serious
injuries.
•
Remove the spark plug cap from the spark plug and
engage the chain brake.
•
Attach the product safely during transportation.
To prepare your product for long-term
storage
1. Stop the product and let it become cool before you
disassemble it.
Technical data
Engine
Cylinder displacement, cu.in/cm
Idle speed, rpm
Maximum engine power acc. to ISO
7293, kW/hp @ rpm
1
Ignition system
Spark plug
Electrode gap, inch/mm
Fuel and lubrication system
Fuel tank capacity, US pint/l
Oil tank capacity, US pint/l
Type of oil pump
1
This spark ignition system complies with the Canadian ICES-002 standard.
1270 - 007 - 06.12.2022
Transportation, storage and disposal
Technical data
435
3
2.49/40.9
2900
1.6/2.2@9000
NGK BPMR 7A/ Champion RCJ 7Y/
Husqvarna HQT-1R
0.02/0.5
0.78/0.37
0.53/0.25
Automatic
2. Disassemble and clean the saw chain and the
groove in the guide bar.
CAUTION:
guide bar are not cleaned, they can
become rigid or blocked.
3. Attach the transportation guard.
4. Clean the product. Refer to
for instructions.
5. Do a complete servicing of the product.
Disposal
•
Obey the local recycling requirements and applicable
regulations.
•
Discard all chemicals, such as engine oil or fuel, at a
service center or at an applicable disposal location.
•
When the product is no longer in use, send it to
a Husqvarna dealer or discard it at a recycling
location.
440
2.49/40.9
2900
1.8/2.4@9000
NGK BPMR 7A/ Champion RCJ 7Y/
Husqvarna HQT-1R
0.02/0.5
0.78/0.37
0.53/0.25
Automatic
If the saw chain and
Maintenance on page 21
33