Publicidad
Idiomas disponibles
Idiomas disponibles
Safety precautions
The information included on the following pages has been prepared to ensure that you get the most from your fan. Carefully follow
these instructions to ensure maximum safety when installing and operating this equipment.
Any action performed on the appliance's
electrical connection, such as cleaning, must
be carried out after ensuring that the general
power supply is disconnected, by removing
the corresponding fuse or "disarming" the
protective switch to ensure total isolation of
the power supply.
The equipment must be installed by a certified
electrician in accordance with the standards
in force in the country where the installation
takes place. Please remember to require your
installer to test all the fan functions before
leaving. In case of any doubt from the installer,
do not hesitate to contact us.
This device may be used by children aged 8
years and above and persons with reduced
physical, sensory or mental capabilities or
lack of experience or knowledge, if they are
properly supervised or trained in the safe use
of the device and understand the dangers of its
use. Children should not play with the device.
The cleaning and maintenance of the device
should not be carried out by children without
supervision.
The mounting bracket must be attached to a
ceiling structure that is capable of supporting
a minimum of 30 kg. At least 30 mm of the
length of the screws must be screwed into
the ceiling. If the fan is being installed onto a
ceiling junction box, secure the fan sufficiently
to prevent it from loosening or rotating.
The system of attaching the fan bracket to the
ceiling will depend on the type of ceiling where
the installation is to be done. The decision
on which attachment system to use and the
quantity is the installer's responsibility.
The fan must be installed to ensure that the
blades are at least 2.3 m above the ground.
Make sure that there is a space of at least 30 cm
between the fan's blades and any wall or other
obstacle with which they could collide. It is
important to note that the greater the distance,
the more efficient the airflow would be.
Customer service and technical support: +34 927 348 671 - Whatsapp: +34 655 89 02 17 Email: atencioncliente@lamparasextremadura.com - www.xtrelamp.com
The fan's ground wire must be connected to the
installation's earth network to avoid any surges
putting people in danger.
Do not connect the fan's power supply to any
regulating elements or potentiometers, as
it could cause the fan to malfunction and/
or will damage the motor. For the electrical
connection, a circuit breaker must be installed
in accordance with the installation regulations,
which ensures a multipole break, is directly
connected to the power terminals and has
contact separation in all poles, which provides
total
disconnection
in
Category III overvoltage conditions. Only use
the fan's control to turn it on or stop it.
It is recommended to not use these types of
fans with gas installations simultaneously in the
same room.
Do not insert anything that could hit the fan's
blades while it is rotating, as this could cause
damage to people, damage the blades and can
offset the unit, causing vibrations and wobbling.
After installing the fan, ensure that all the
fastenings are secure and tightened in order to
avoid any noise caused by loose elements.
Some fastenings may become loose due to
the fan's movement. Check all fastenings at
least twice a year to ensure that they are tight
enough. If necessary, they must be retightened.
If the power cable is damaged, it must be
replaced by the manufacturer, its after-sales
service or similar certified personnel to avoid
any hazard.
Replaceable receiver and remote control.
Do not dispose of electrical products with
household waste. Please recycle the packaging
at designated collection points. Contact the
local authorities or your service provider for
recycling advice. Thank you for recycling at the
designated collection points
EN
accordance
with
11
Publicidad
