FORCE PLAY FPYMS2IN1SPEAKERS Guia De Inicio Rapido página 3

BUTTON FUCTION
ON/OFF LIGHT :
- Short touch to turn on/off the light
- Long press to adjust brightness
INCREASE :
- Short press to increase the volume
- Long press to switch to the next song
PLAY/PAUSE :
- short press to play / pause the music
- Long press to turn on / off the speaker
REDUCE :
- Short press to decrease the volume
- Long press to switch to the previous song
SPEAKER INSTRUCTION
- Press and hold the play/ pause button, there will be
a prompt tone: the Bluetooth function of the speaker
will be activated.
- To pair, activate your phone's Bluetooth function. In
the Bluetooth devices list, «Enceinte sans fil» appears.
- Tap to select the device name « Enceinte sans fil »:
Pairing takes place automatically.
- Once the pairing connection is successful, there will
be a prompt tone.
- Press and hold the play/pause button again to switch
off the speaker function.
TIP !
By specifying the type of device, you ensure that the sound level
measurements are correct :
On IOS
Select Bluetooth name «Enceinte sans fil» > Device type >
Speakerphone.
On Android
Select Bluetooth name «Enceinte sans fil» > settings icon > audio then
audio device type > speaker.
WARNING! Risk of hearing damage
- Set a low volume on the playback device before you connect the
headphones to the sound source.
- Avoid excessive volumes, particularly over extended periods or in the
case of frequent use. Excessive volume can result in permanent hearing
damage.
Read the manual carefully before use. Keep the manual for future use.
Handle your device, charger and accessories with care. The following suggestions
will help keep your device working properly. Keep the device dry. Rainwater, moisture
and liquids contain minerals that can damage electronic circuits. Do not handle the
appliance with wet hands, Do not immerse the device in any liquid, Use the charger
only for its intended purpose. Inappropriate use, or use of incompatible chargers may
present a risk of fire, explosion or other hazards. Never use a damaged charger, Do
not attempt to charge a device with a damaged, cracked or open battery case, Do not
use or store your device in a dusty or dirty location, Do not store the device in high-
temperature areas. High temperatures can damage the device, Do not store the device
in low-temperature areas. When the device returns to its normal temperature, moisture
may form inside and damage it, You risk damaging the device and violating the
regulations covering high-frequency transmission equipment if you make unauthorised
adaptations, Do not drop or strike the device or battery, or shake them. Rough handling
could break it, Use only a soft, clean, dry cloth to clean the device. The device may
become hot during prolonged use. In most cases, this is normal. If the device does not
operate properly, contact your nearest authorised service centre, Keep the device out of
the reach of children.
SAFETY AND PRECAUTIONS
1. This product is for indoor use only.
2. Do not expose it to dust or extreme heat. High temperatures can damage the device.
3. This device must be used in a temperate climate, away from direct sunlight, open
flames, heat, heating appliances, stoves or any other equipment that generates heat
(including amplifiers). Do not install it near to sources of heat.
4. Do not expose it to moisture or any liquid.