NICREW RGB+W 24-7 Manual De Instrucciones página 6

2. Press , the display will flash "1 00" which is the default se�ng.
The first digit is the channel number you are se�ng (1=White,
2=Red, 3=Green, 4=Blue). Press H/+ or M/- to increase or decrease
the brightness of White LEDs.
again, the display will flash "2 100". Press H/+ or M/-
3. Press
to increase or decrease the brightness of Red LEDs.
4. Repeat step 3 for se�ng the brightness of Green and Blue LEDs.
to save and exit P1 se�ng.
5. Press
6. Repeat step 1 to 5 to program P2, P3, P4 and P5 se�ng.
Set the Ramp Time
Press Ramp to adjust ramp �me, press H/+ or M/- to choose from
the following modes.
Display
0
15 minutes Sunrise
15
30 minutes Sunrise
30
Press to save and exit ramp �me se�ng.
NOTE:
• When the LCD displays the start �me of ligh�ng phase, press
the remote to disable the corresponding ligh�ng phase. Press
again to resume programming.
• In �mer mode, if you set the ramp �me for 15 minutes, at sched-
uled on �me, the light will slowly ramp up from 0% to 100% in
15 minutes simula�ng a gradual sunrise. At the off �me, the LED
will slowly dim down from 100% to 0% brightness in 15 minutes
simula�ng a sunset.
• When using your wireless remote, point the remote directly at
the IR sensor located on the inline IR controller. It is important to
have a direct line of sight between the remote and the controller.
Func�on
Straight On/Off
and Sunset
and Sunset
Descrip�on
Switching on or off automa�cally
without dimming
Ramp up and dim down from
0% -100% -0% for 15 minutes each
Ramp up and dim down from
0% -100% -0% for 30 minutes each
English
on