Powering On The Microbrite Color Lights - Pentair MICROBRITE Guía De Instalación Y Del Usuario

2
Operating MicroBrite™ Color LED Light using a Wall Switch
MicroBrite Color Lights can be controlled using a standard wall-mount light switch (or by
the IntelliBrite Controller, see page 4). Multiple MicroBrite color lights can be connected
®
via a junction box and a 12 VAC transformer to a single switch so that all lights can be
switched on and off together. MicroBrite color lights are controlled by cycling AC power
to the 12 VAC transformer from a standard wall switch. By turning the switch on and off
a specific number of times, the light activates one of the seven light show modes, fixed
colors, or enables the "Hold" and "Recall" feature.

Powering on the MicroBrite Color Lights

When the MicroBrite color light is powered on, the previously selected color is displayed,
unless the HOLD or RECALL feature was previously enabled.
: If power to the light is off for more than five (5) seconds, the last color show mode or
Note
fixed color that was saved will be displayed.
Selecting a MicroBrite Color Light Show Mode or Fixed Color using a Wall
Switch
MicroBrite color lights are compatible with IntelliBrite
synchronized with IntelliBrite color lights.
First switch power on to the light. A white light will momentarily illuminate, followed by the
previously selected color. To select a color show mode (1-7) or fixed color
(8-12), turn the wall switch off/on a specific number of times. Each number (1-12) shown
below corresponds to the number of times to power-cycle the switch to activate a color
light show or fixed color. For details about saving color effects while in "show" modes, see
"Hold" and "Recall" feature on page 4.
1 SAm Mode:
(emulates the Pentair SAm color changing light).
2 Party Mode:
3 Romance Mode:
calming effect.
4 Caribbean Mode:
5 American Mode:
6 California Sunset Mode:
magenta tones.
7 Royal Mode:
Fixed color.
8 Blue:
Fixed color.
9 Green:
Fixed color.
10 Red:
Fixed color.
11 White:
12 Magenta:
Save the current color effect during a color light show.
13 Hold:
14 Recall:
To select
Example:
times. During the off/on switching process, no illumination will occur, then a white light will
momentarily illuminate.
WARNING During the off/on switching process, before the selected color is displayed, no illumination
will occur. This operating mode is normal during the switching process. During this period the pool and spa
will be dark and precautions should be taken to avoid unforeseen accidents. Failure to observe this
warning may result in serious injury or death to pool and spa users.
MicroBrite Color and White Light Installation and User's Guide
Cycles through white, magenta, blue and green colors
Rapid color changing building energy and excitement.
Slow color transitions creating a mesmerizing and
Transitions between a variety of blues and greens.
Patriotic red, white and blue transition.
Richer, deeper color tones.
Fixed color.
Activate the last saved color effect.
California Sunset Mode
Color Light shows and can be
®
Dramatic transitions of orange, red and
; turn the switch on, then off and on six (6)