Publicidad
Idiomas disponibles
Idiomas disponibles
BUTTON
TIMER
Pressing this button will cycle the fan
through 3 comfort speeds
(High/Medium/Low).
SPEED
Use this button to turn the fan ON/OFF.
ON/OFF
Using the Remote Control
Your remote control requires two AAA batteries (not included) for operation. To install the batteries, simply slide out
the battery cover with your thumb on the mark
shown inside.
Replace the battery cover.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
If the remote control will not be used for a long period of time, remove the batteries from the battery compartment.
Non-rechargeable batteries are not to be recharged.
Batteries are to be inserted with the correct polarity.
Exhausted batteries are to be removed from the product.
Controlling the Fan Oscillation
To oscillate the fan head horizontally (left to right), push down the Oscillation Knob located on the top of the Motor
Housing. To stop fan from horizontal oscillation, pull up the Oscillation Knob.
Adjusting the Height of the Fan
Loosen the Height Adjustment Knob in a counterclockwise direction, adjust the length of the Height Adjustable Pole,
tighten the Height Adjustment Knob in a clockwise direction.
CAUTION: The fan should be switched off before making this adjustment.
Adjusting the Tilt of the Fan Head
To adjust the tilt of the fan head to the desired angle, push gently up or down on the fan grilles while holding the fan
by the Motor Housing.
CAUTION: The fan should be switched off before making this adjustment.
CARE AND MAINTENANCE
This appliance requires little maintenance and contains no user serviceable parts. Do not try to fix it yourself. Refer it to
qualified service personnel if servicing is needed.
This fan is permanently lubricated and will not require additional lubrication for the life of the fan.
TO CLEAN: Before cleaning, turn fan off and unplug from electrical outlet. Wipe off excess dust with a lint-free cloth. To
ensure adequate air circulation to the motor, keep vents located at the rear of the motor housing free from dust
accumulation. A vacuum cleaner hose can be used to clean these vents. Do not submerge your fan in water or any other
liquid. Disassemble grilles and blade. Grilles and blade may be cleaned with mild soap and water. Use a soft, slightly damp
cloth to wipe the remaining fan parts. Do not allow water or any other liquid to get into the motor housing. Reassemble fan
after grilles and blade have dried completely. Do not plug fan into electrical outlet until it has been fully reassembled.
TO STORE: Make sure to disassemble and clean the fan before storing. Retain the original packaging for the purpose of
storing your fan. Always store fan in a dry place. Never store it while it is still plugged in. Never wrap the cord tightly around
the fan, and do not put any stress on the cord where it enters the fan, as it could cause the cord to fray and break.
FUNCTION
Pressing this button sets the
timer in increments of 1 hour to a
maximum of 7 hours. After the
timer runs out, the fan will
automatically shut off.
1hr, 2hr, 4hr.
Example 1: 1hr illuminated indicates the timer will shut
off after 1 hour.
Example 2: 1hr and 2hr illuminated indicate the timer will
shut off after 3 hours.
Example 3: 1hr, 2hr and 4hr illuminated indicate the timer
will shut off after 7 hours.
in the right direction. Insert the batteries according to the indication
6
DISPLAYED
These icons indicate the
selected speed (low, medium,
or high).
Publicidad
