Descargar Imprimir esta página

FRIGOGLASS MAX-150 B Manual De Usuario página 11

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 110
ENG
3.1
Installation instructions
i.
In case the cooler of MAX 450 is packed by the full-face packaging, after unpacking, you need to
remove carefully the protective films that are stuck on the door horizontal profiles.
ii.
After unpacking, check the cabinet for any damage caused during transportation. In the event of
damage, please contact the forwarding company.
iii.
Always ensure that your merchandiser is installed on a stable & even surface/floor and is
properly leveled. Proper leveling is achieved when the cooler is tilting slightly backwards.
There are 2 adjustable feet at the front, under the chassis. The cooler must be leveled through proper
adjustment of the leveling feet in all installations. It must be ensured that the cooler does not exhibit
any inclination towards its front side and/or its lateral sides, after adjustment. A slight inclination toward
its back side will further facilitate the good circulation of the fluid and support the door closing
mechanism. The use of a spirit level is highly advisable to check leveling. Verify that the cooler sits
firmly on the leveling feet. The front cooler wheels (if available) should be able to rotate by hand after
cooler installation and adjustment. There are 2 or 3 (depending on the size) adjustable feet for all
models at the front under the chassis. The level foot must be adjusted in such a way that the lower
edges of the internal cabin are aligned. The below given check points must be on the same line.
11
Keep clear of obstruction all ventilation openings in the appliance
enclosure or in the structure for building-in.
Do not use mechanical devices or other means to accelerate the
defrosting process, other than those recommended by the
manufacturer.
Do not damage the refrigerant circuit.
Do not use electrical appliances inside the food storage
compartments of the appliance, unless they are of the type
recommended by the manufacturer.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.

Publicidad

loading