Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting Screws
UL Listed
Outlet Box
Slide Mounting
Plate Over
Screw Heads
120V Wires
Motor Wires
Ball/Downrod
Canopy
Assembly
Canopy Ring
Motor
Locking Pin
Collar
Cover
Motor
Collar
Tighten Screws
"Close-to-Ceiling" Mounting
(Supplied With
1. Remove the canopy ring from the canopy
Outlet Box)
by turning the ring to the right until it
unlocks (Figure 5).
Hook
2. Remove the mounting plate from the cano-
py by loosening the four screws on the top
of the canopy. Remove the two non-slotted
screws and loosen the slotted screws. This
Ceiling
will enable you to remove the mounting
Mounting
plate (Figure 6).
Plate
3. Remove the decorative canopy bottom cov-
er from the canopy by depressing the three
studs (Figure 8).
Pin in
Locked
Canopy
Bottom
Position
Cover
Hanger
Pin
4. Remove three of the six screws and lock-
washers (every other one) securing the re-
inforcing plate to the top of the fan motor
housing (Figure 9).
5. Place the rubber gasket over the remaining
three screws, route the wires exiting the top
Figure 7
of the fan motor through the ceiling cano-
py over the collar at the top of the motor
(Figure 10).
6. Align the mounting holes with the holes
in the motor and fasten, using the three
screws and lock-washers removed in step 4
(Figure 10).
7. Tighten the mounting screws securely.
FAILURE TO PROPERLY INSTALL SET SCREWS
IN STEP 7 COULD RESULT IN FAN LOOSENING
AND POSSIBLY FALLING.
Motor
Collar
Collar
Figure 8
Ceiling
Canopy
Screw and
Lockwasher
(3 of 6 Screws)
Figure 9
Screw and
Lockwasher
(3 screws)
Canopy
Ring
Rubber
Gasket
Figure 10
5.
Publicidad
