Publicidad
Idiomas disponibles
Idiomas disponibles
Ice Maker Installation
UNPACKING
Use two or more persons to move and install ice maker
Failure to do so can result in back or other injury
REMOVE PACKAGING MATERIALS
IMPORTANT: Do not remove any permanent instruction labels or the data label on your ice maker.
Remove tape and glue from your ice maker before using,
• To remove any remaining tape or glue, rub the area briskly with your thumb Tape or glue residue
can also be easily removed by rubbing a small amount of liquid dish soap over the adhesive with
your fingers. Wipe with warm water and dry.
• Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove
tape or glue These products can damage the surface of your ice maker
• Leave lowermost foam panel in place until after the adjustable feet are attached
Cleaning before use
After you remove all tape and glue from the machine, clean the inside of your ice maker before using
it See "Interior Cleaning" in the Cleaning and Maintenance section
Installing the adjustable feet
At least two persons are required to install the adjustable feet.
You will find four adjustable feet packed in the ice storage bin. To install, tilt one side of the unit and
screw in two adjustable feet, as illustrated (IMPORTANT: Do not tilt the unit more than 45º) Then tilt
the other side and screw in the remaining two feet
SERVICE AND INSTALLATION MANUAL
DANGER
WARNING
Excessive Weight Hazard
CAUTION
Lower foam panel
www.maxxfoodservice.com
6
Publicidad
