Publicidad
Idiomas disponibles
Idiomas disponibles
MB1500 FRONT PANEL INSTALLATION
MB1500/F1000-UPS FRONT PANEL INSTALLATION
The MB1500 is shipped with the front panel unattached to ensure that no damage is caused during shipping. Before the MB1500 can be used, the front panel must be installed.
The MB1500 is shipped with the front panel unattached to ensure that no damage is caused during shipping. Before the MB1500 can be used, the front panel must be installed.
A. CAUTION: RISK OF EXPLOSION IF BATTERY
IS REPLACED BY AN INCORRECT TYPE."
B. CAUTION: When replacing batteries,
replace with the same type of the original
batteries
C. CAUTION: Before replacing batteries,
remove conductive jewelry such as chains,
wrist watches, and rings. High energy through
conductive materials could cause severe
burns;
D. CAUTION: Do not dispose of batteries in a
fire. The batteries may explode.
E. CAUTION: Do not open or mutilate batter-
ies. Released material is harmful to the skin
and eyes. It may be toxic.
MB1500 BATTERY REPLACEMENT
MB1500/F1500-UPS BATTERY REPLACEMENT
1
. Remove the front panel. Remove the rubber end caps and pull up on the latch mechanism. Once the latch mechanism stops,
gradually pull the front panel off of the MB1500.
3
. Disconnect both the red and black connectors.
5
. Install the new battery pack into the unit. DO NOT ATTEMPT TO REPLACE THE BATTERIES
IN THE ORIGINAL BATTERY PACK. IMPROPER INSTALLATION CAN RESULT IN FIRE OR
BATTERY LEAKAGE.
8
. Reinstall the front panel per the Front Panel Installation instructions.
1
. Remove front panel from shipping
inserts (pic, CP to provide)
2
. Verify that the battery connectors are
connected, red-to-red, black-to-black.
If not connected, perform steps 2 and 6 in
the BATTERY REPLACEMENT section.
(Part #BC-1500, Contact Panamax to order replacement battery)
4
. Remove the screws from the battery pack (part number BC-1500) and pull the battery pack out of the unit using the integrated handle.
3
. (Optional) Install the supplied rubber
end-caps to the sides of the front panel.
Push the curved edge of the end-cap into
the mating slots of the front panel.
2
the battery connector.
6
. Reconnect the battery cable connectors.
WARNING!
ALWAYS CONNECT RED to RED and BLACK to BLACK.
If the cable connectors do not snap together easily as RED to RED and BLACK
to BLACK, NEVER attempt to force them together or flip connectors over
resulting in a RED to BLACK combination which will cause electrical
sparking, shock, fire or explosion! Call customer service for help.
2
4
. Carefully align the front
panel connector and latches
with the MB1500.
. Remove the screw from the battery connector security plate to release
5
. Gradually apply pressure to the
left and right ends of the front panel
until you hear the latches 'click'.
7
. Reinstall the battery connector
security plate.
Publicidad
