Publicidad
Idiomas disponibles
Idiomas disponibles
• When the unit is plugged in for the first time, the LED readouts will show the original temperature set
previously. Touch the "+" (C) and "-" (B) mark once of each compartment to set the desired
temperature.
• The temperature will increase by 1°C or 1ºF if you touch the "+" (C) mark once, or the temperature will
decrease by 1°C or 1ºF if you touch the "-" (B) mark once.
When the surrounding temperature is 25℃ and the wine cooler has no bottle loaded, it will take
around 12 minutes to increase the wine cooler's temperature from 5℃ to 12℃. Under the same
circumstance, it will take around 25 minutes to decrease the wine cooler's temperature from 12℃ to
5℃. The less the temperature span is, the less time it will take. The setting temperature of upper
zone should be lower than the setting temperature of lower zone
Temperature display
Display show at its setting.
To view the actual temperature in either zone at any time, touch key (B) and key (C) for 3 second, the
display will display two zone's actual temperature with flashing, and it will quit by holding stop.
NOTE: when first used or after operating the wine cellar after a long period of inactivity, the inner
temperature will not immediately be the temperature setting on the display. Indeed, it is necessary to wait
a few hours for a temperature adjustment of the wine cellar in order to have a homogeneous temperature.
To avoid excessive condensation when the ambient temperature is above 28°C, do not lower the
temperature to below 7°C.
IMPORTANT: after unplugging, turning off the power or after a power failure, it is imperative to wait
5 minutes before turning it on again.
Temperature alarm
Your appliance is equipped with a visual and audible temperature alarm. If the error codes HH and LL
appear on the control panel display, check that you are not in the following situations:
- The appliance door is not closed properly
- The appliance has been switched on within the last 24 hours, or you have added a large quantity
of bottles at one time. In this case it may take longer to reach the required temperature. The initial
ambient temperature or the number of bottles installed in the appliance may have an impact on the
internal temperature.
If this is not the case, switch off and unplug the appliance and contact the Service Department with the code
that was displayed.
Door alarm
If the door has been left open for more than 60s, the alarm will sound. Press key I once to stop the sound
alarm if the noise disturbs you.
Interior light
The interior light makes it easy to view your wines labels and enhances the display of your collection.
Touching and holding the
lights:
-
Functional mode (default): the light will turn on only when the door is open, this is the most
economic mode
-
Showcase mode: light will turn on/off only by short touching of light key J.
mark (J) 5 seconds toggles between two modes of operation for the internal
44
Publicidad
