28 | English
(3)
After fitting, check that the edge of the abrasive tool
u
(➍) is fitted correctly, i.e. is no higher than the refer-
ence surface (➎). If the edge is higher than the refer-
ence surface, either the holder must be cleaned or the
abrasive tool must not be used.
Before removing the grinding/cutting/flap disc: Make
sure that the power tool has come to a complete stop.
Removing the abrasive tool
➊ Open the lever (3).
➋ The grinding/cutting/flap disc will be released.
➌ The grinding/cutting/flap disc can be removed.
(3)
Approved abrasive tools
You can use all the abrasive tools mentioned in these operat-
ing instructions.
The permissible speed [min
] or the circumferential speed
-1
[m/s] of the abrasive tools used must at least match the val-
ues given in the table.
It is therefore important to observe the permissible rota-
tional/circumferential speed on the label of the abrasive
tool.
1 609 92A 6A2 | (10.10.2022)
Max. [mm]
D
125
125
125
75
125
125
83
125
s
α
Rotating the machine head (see figure E)
Pull the plug out of the socket before carrying out any
u
work on the power tool.
The machine head can be rotated in 90° increments. In this
way, the on/off switch can be brought into a more favourable
handling position for particular applications, e.g. for left-
handed tool users.
Completely unscrew the four screws (➊). Rotate the ma-
chine head carefully, without removing it from the hous-
ing, into the new position (➋). Screw in and retighten the
four screws (➌).
Removing the Dust Filter (see figures F and G)
Slide off the dust filter (5) at the bottom of the power tool in
the direction of the arrow.
(3)
Do not hold the dust filter (5) by its sides and do not pull it
off.
Dust/Chip Extraction
The dust from materials such as lead paint, some types of
wood, minerals and metal can be harmful to human health.
Touching or breathing in this dust can trigger allergic reac-
tions and/or cause respiratory illnesses in the user or in
people in the near vicinity.
Certain dusts, such as oak or beech dust, are classified as
carcinogenic, especially in conjunction with wood treatment
additives (chromate, wood preservative). Materials contain-
ing asbestos may only be machined by specialists.
[mm]
[°]
b
s
d
α
[min
7.2
–
X-LOCK
–
11500
–
4.2
–
X-LOCK
–
11500
–
–
X-LOCK
–
11500
30
–
X-LOCK
–
11500
19
–
X-LOCK
–
11500
–
–
X-LOCK
–
11500
–
–
X-LOCK
–
11500
6
10 X-LOCK > 0 11500
Bosch Power Tools
-1
] [m/s]
80
80
80
80
80
80
80
80