Kenmore ULTRA WASH 665.1272 Serie Manual De Uso Y Cuidado página 21

PROBLEM SOLUTION
HARD WATER NOTE: Extremely hard water mineral deposits can cause damage to your dishwasher and make
(WHITE RESIDUE ON it difficult to achieve good cleaning. You may bring water samples to Sears to check your water
DISHWASHER INTERIOR OR hardness level. A water softener is strongly recommended if your hardness is 15 grains or more. If
GLASSWARE) a water softener is not installed, the following steps may help:
Use a commercial cleaner designed for dishwashers once per month.
Clean the ULTRA WASH ®HE filters at least once per month.
Always use a rinse aid.
Always use a high-quality, fresh detergent.
Use a detergent boosterJwater softener additive designed for dishwashers.
ODORS
NOISY
NOTE: If the dishwasher is not used daily, you can run a rinse cycle with the partial load until a
full load is ready to run, or use the Top Rack Only option (on some models) for partial loads.
Run a vinegar rinse through the dishwasher by putting 2 cups (500 mL) of white vinegar in an
upright glass measuring cup in the lower rack. Run a normal cycle with the Heated Dry option
turned off. Do not use detergent.
The dishwasher may not be draining properly, see "WATER REMAINS IN THE TUBJWILL NOT
DRAIN" in "Troubleshooting."
NOTES;
• Surging sounds can occur periodically throughout the cycle while the dishwasher is draining.
• Normal water valve hissing may be heard periodically.
• A normal snap sound may be heard when the detergent dispenser opens during the cycle
and when the door is opened at the end of the cycle.
• Improper installation will affect noise levels.
Be sure the filters are properly installed.
A thumping sound may be heard if items extend beyond the racks and interfere with the wash
arms. Readjust the dishware and resume the cycle.
FOOD SOILS REMAIN
ON DISHES
Be sure the dishwasher is loaded correctly. Improper loading can greatly decrease the washing
performance (see "Loading for Best Cleaning and Drying Performance").
Check filter to ensure it is properly installed. Clean it if needed. (See "Cleaning Instructions" in
"ULTRA WASH ® HE Filtration System" for details.)
Select the proper cycle and option for the type of soils. The Pots & Pans cycle can be used for
tougher loads.
Be sure the incoming water temperature is at least ]20°F (49°C).
Use the proper amount of fresh detergent. More detergent is needed for heavier-soiled loads
and hard water conditions.
Scrape food from dishes prior to loading (do not prerinse).
DID NOT SANITIZE If the sanitized light is blinking, the load is NOTsanitized. The cycle was interrupted in the final
rinse, or your water heater is set too low. Set your water heater to ]20°F (49°C).
DAMAGE TO DISHWARE Improper loading can cause dishes to become chipped or damaged. (See specific loading
instructions within this guide.)
BLINKING LIGHTS If Start or any status lights are blinking and the dishwasher will not run, close the door and push
START. If the dishwasher still will not run, call service.
21