Publicidad
CARRY-BIKE
EN
Read the following instructions and warnings carefully; failure to observe these installation and
usage instructions as well as the Highway Code in the relevant country may cause severe harm
or damage for which the manufacturer declines all responsibility. Before installation, ensure
compatibility with the vehicle on which the product must be installed.
Checking that the wall/rear door is suffi ciently solid and suitable for guaranteeing the resistance of
the anchoring points is always mandatory. If not, strength and compliance with the maximum load
indicated in the instructions are not guaranteed and it will be necessary to reinforce these points.
After having positioned the Carry-Bike on the rear axle of the vehicle, the normal weight
distribution on both axles is modifi ed. This variation must not exceed the maximum permissible
axle load.
Never exceed the maximum permitted length and the total weight of the full-loaded vehicle.
Make sure that the weight is correctly distributed while loading; a uniform distribution (the heaviest
bike must be placed in the rail guide near the wall of the vehicle) ensures better stability.
Always warn about the presence of the Carry-Bike on your vehicle, using a sign for protruding
loads and, in case of limited rear visibility, use the additional rear-view mirrors.
Take into account the presence of the Carry-Bike, paying attention during driving and expecially
during reversing manoeuvres, particularly if you have parking assist system.
Always comply with speed limits and the Highway Code.
The speed should always be suitable to traffi c conditions and towed load.
In case of use of the bike carrier with tow make sure that the tow hook is always accessible and
the corner mobility of the tow is guaranteed (volume measuring din 74058).
Moderate the speed of the vehicle on rough roads or bottoms.
Pay attention to the road bumps, they are to be taken without exceeding the speed limits allowed.
Check periodically the bicycle rack to make sure it is fi rmly attached, especially during the fi rst
kilometers of after long trips to avoid damages of the Carry-Bike/vehicle.
During Carry-Bike installation, verify that there is enough distance between handlebars and/or
pedals and the vehicle's rear windows in order to avoid any damages of the window van; do not
leave accessories attached (bay seats, baskets, etc) because vibrations could disengage bikes.
In some cases, the rear windscreen wiper may not work due to the presence of bicycles. Be
aware of the brush radius before operating the windscreen wiper.
On this type of Carry-Bike, bike covers are not allowed (Bike Cover).
It is advisable to remove the batteries from bicycles, before loading them on the Carry-Bike while
traveling.
Depending on the type of bicycles transported, check the correct visibility of the rear lights. If the
visibility is missing, provide a light repeater bar.
It is recommended to rotate the handlebars of bicycles to avoid damage to the vehicle wall, for
which Fiamma declines all responsibility.
19
Publicidad
