Publicidad
Idiomas disponibles
Idiomas disponibles
Lumens and CCT Operations
SELECTING LUMENS
High Beam: 4000 Lumens
Low Beam: 1500 Lumens
NOTE: The default setting is 4000 lumens.
Set to
If these settings are acceptable for your needs, you don't need to do anything more
with the SetToGo settings except to do the actual electrical installation of the fixture.
ATTENTION!
THE FIXTURE CANNOT BE USED AS A DUSK-TO-DAWN LIGHT. THE FIXTURE HAS A
BUILT-IN LIGHT SENSOR THAT PREVENTS THE MOTION SENSOR FROM ACTIVATING
DURING DAYLIGHT HOURS.
1
When the MINUTES control is
set to MOTION TEST, the light
will operate both during
daylight and nighttime.
8
Light Orientation
To adjust the angle of the light, loosen the
two knobs on the back of the light and
position the light as preferred (up and down,
or left and right). Once in position, tighten
both knobs to lock the light into place.
FACTORY PRESETS
SetToGo: The security light is PRESET at the factory
with the following settings:
Range: 50 feet
Minutes: 3 min.
(duration)
To change the factory SetToGo default settings, follow the
instructions below.
Customize Settings
MOTION TEST MODE TO SET DISTANCE
Rotate the MINUTES control knob to MOTION TEST to
calibrate the fixture. The light will turn on for approximately
20 seconds.
Allow the motion sensor about 2 minutes to
warm up prior to conducting the "walk-by test".
With the control knob set to MOTION TEST, do a "walk-by
test" by walking in front of the motion sensor (figure at right).
As movement is detected, the light will activate. Remain still for approximately 5
seconds (when movement is no longer detected), the light will shut o . Resume
walking and the light should turn on. Once out of the detection range, the light will
shut o and the test is complete.
SELECTING COLOR TEMPERATURE
Warm White: 3000K
Bright White: 4000K
Daylight: 5000K
NOTE: The default setting is 5000K.
Detection distance
to MAX.
Time the light stays on after
detecting motion
Light
Activation:
3 min.
Walk-By Test
180°
Publicidad
