Publicidad
Step 4
å
Fasten the UPRIGHTS (D and E) to the TOP (T2).
Tighten four TWIST-LOCK® FASTENERS.
å
Slide the CENTER BACK (O) into the grooves of
the UPRIGHTS (D and E).
How to use the SAUDER TWIST-LOCK
1. Insert the dowel end of the FASTENER into the
hole of the adjoining part.
NOTE: The dowel end of the FASTENER must
remain fully inserted in the hole of the adjoining
part while locking the FASTENER.
2. Tighten the FASTENER with a Phillips
screwdriver as tight as possible.
Dowel end
Meet Part (T2). This component has
been engineered to be lighter, stronger,
faster... well ok. Not technically faster.
But definitely makes for a sturdier
Hutch that' s easier to assemble and
friendlier to the environment.
Page 8
FASTENER
®
D
These holes must be here.
422983
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
O
F i n
i s h e
d s
u r f a
c e
Groove
E
T2
2
Just think. The sooner
you do this, the sooner
you do something else.
www.sauder.com/service
Publicidad
