Publicidad
Idiomas disponibles
Idiomas disponibles
COMPONENTS:
3 Supporting rings
4 External textured sides
1 Concrete Woodshed back
1 Concrete floor
1 Refractory floor
2 Internal refractory sides
1 Refractory back
2 Back weight bearing
1 Grill with zinc bathed adjusting mechanism
1 Cooker hood
1 Chimney extension
1 Chimney hood
1 kit containing 0,25 L paint can, 8 screw and 2
back staples
If the model is N02 with Fire Space, add:
3.2mm sheet metal stove separator + 2 (two)
1/4 milled screws + clamp for internal side +
Binelli log holder
ASSEMBLY STEP BY STEP:
CONDITIONING AND PREPARATIONS:
Clearly define the location where the grill is going to be assembled. The grill must be assembled on a firm and
resistant floor that does not give way due to the weight of its structure. This is for both exterior and interior
assembly. The area where the assembly is to be carried out must be clean and tidy.
Position and level the base ring. Place it on the floor, remove it 1.5 cm from the wall line to be
STEP 1:
able to later place the screws of the back weight bearing (in the event that there is a wall). Level with a
bubble level.
Note: the grill is self-supporting, it does not require support against a wall.
N02
To level
FRONT VIEW
Ring (3)
External side
Internal refractory side
Grill
Reflactory floor
External side
Ring (2)
Concrete floor
Ring (1)
Remove 1,5cm from de wall
Chimney hood
Chimney extension
Cooker hood
Refractory back
Woodshed back
Internal refractory side
External side
External side
wall
LATERAL VIEW
www.parrillasbinelli.com
Back weight
Back weight
/parrillasbinelli
Publicidad
