BINELLI CLASICA N02 Manual Del Usuario página 8

STEP 2 : Place the concrete floor + external sides + back weight bearing. Place the concrete floor inside
the ring, position sides on the floor plate. Fasten the back weight bearing to the ears with the ¼" screws
with nuts and washers. Center and adjust the assembly.
Back weight bearing
STEP 3 : Place the woodshed back. Place the woodshed back in the support position against the back weight
bearing and place the clamps, adjusting them with the upper screws of the back weight bearing.
Woodshed back
FRONTAL VIEW
STEP 4: Place the ring and refractory floor. Position the ring on the back and the lower external sides,
fitting the lower molding to center it with the assembly. House the refractory floor inside the ring.
FRONTAL VIEW
N02
Concrete floor
Base ring
FRONTAL VIEW
Clamps for woodshed back
Refractory floor
Ring
External side
Screws
+ nuts
+ washers ¼"
Woodshed back
REAR VIEWS
Refractory floor
Ring
Bottom
molding
REAR VIEW
Screws + nuts + washers ¼"
REAR VIEW
www.parrillasbinelli.com /parrillasbinelli