Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS (Continued)
13. Position the fan housing (A) so the bottom edge of the fan
housing (A) is flush with the ceiling board. Do not flush mount the
fan housing (A) to the joist.
Attach the end of each of the suspension brackets (D) to the
ceiling joists using wood screws (AA).
Secure the suspension brackets (D) to the fan housing (A) using
the machine screws (BB).
Hardware Used
AA
Wood screw
BB
Machine screw
14. Remove the wiring box cover from the fan housing (A). Pull the
house wires through the hole in the wiring box cover (14.1).
Using the quick connectors, connect the house wiring from the
wall switch to the fan housing (A). 14 AWG is the smallest
conductor that should be used for branch circuit wiring. Please
refer to the wiring diagram on page 5 to ensure proper wire
connections are made. Carefully push the wire connections into
the wiring box and reattach the wiring box cover (14.1).
CAUTION: If the electrical wires do not match the colors listed,
you must determine what each house wire represents before
connecting the wiring. You may need to consult an electrical
contractor to determine how to make the electrical connections
safely.
15 . Connect a 6 in. circular duct (15.1) to the duct connector (15.2) on
the fan housing (A), securing it with duct tape or a clamp. Vent the
duct to the outside.
Note: If available ducting is 4 inches in diameter, the optional
duct adapter (C) can be used to reduce the 6 in. duct connector
(15.2) on the fan housing (A) to the 4 in. ducting. Use duct tape
or a clamp to secure the ducting to the adapter to create an air
tight seal.
13
BB
x 8
x 4
14
15
Joist
A
10
Ceiling joists
D
Joist
AA
Ceiling board
Quick
connector
14. 1
15. 1
15.2
C
A
14. 1
Joist
Publicidad
