Garland BULK 316 E-V20 Manual De Instrucciones página 40

English
If the chain is tensed again when hot, you must check
the chain tension when you have finished work as
when the chain cools down it will tend to tense and if
too tense it could damage the chain.
New chains need some time until the teeth adapt
and this could modify slightly the length of the chain.
This adaptation takes only a couple of minyes when
in use. If you have just changed the chain, remember
to check the tension of the chain after a couple of
minutes using the machine.
6.4. START UP AND STOPPAGE
Security button
ON/OFF Switch
Letting go of the on/off switch will stop the chain
of the machine in 0.15s. When the switch is not
functioning the conexion of the engine to the chain is
stopped thanks to a clutch. You will observe that the
chain stops even although the engine has not stopped
until a few moments later.
6.5. POINTS TO BE VERIFIED
6.5.1. VERIFYING THE KICK BACK PROTECTION
The kick back is the biggest danger of this
machine. This machine has an automatic
security brake to stop the chain from moving should
an unexpected kick back occur during its use.
To verify the correct function of the automatic brake:
1. Start the machine and keep it on.
Starting the machine:
Press down on the security
button and without letting
go, press the on/off switch.
Stopping the machine:
Let go of the on/off
switch.
2. Push forward the chain brake with your left hand.
3. The chain shoul stop inmediately.
If the chain does not stop inmedately or it takes too
long to stop, take the machine to your after sales
technician.
Check the chain brake prior to each use.
6.5.2. VERIFYING THE OIL LUBRICATION SYSTEM
7. USING THE MACHINE
Only use this machine for those jobs it has been
designed to do. The use of this machine for any other
use is dangerous and could cause damages to you
and/or the machine.
Only cut wood. Do not use the machine for any
other use. For example: do not use the machine to
cut plastic materials, bricks and other construction
materials that are not wooden. The use of the machine
for other uses could cause dangerous situations.
This machine has not been designed to carry out
forestal work. Due to the electric conexion, the end
user does not have sufficient autonomy to guarantee
his/her security.
Do not come near the chain when the machine is
functioning.
40/152
After start up, accelerate
the chainsaw until the chain
rotates at a medium speed and
verify that the chainsaw has oil
lubrication. To check this, place
the machine as in the figure
and check that oil comes off
the tip of the bar.